ATxmega64A3 Atmel Corporation, ATxmega64A3 Datasheet - Page 179

• Manufacturer Part Number: ATxmega64A3
• Manufacturer: Atmel Corporation

Specifications of ATxmega64A3

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 50
• Ext Interrupts: 50
• Usb Speed: No
• Usb Interface: No
• Spi: 10
• Twi (i2c): 2
• Uart: 7
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 7
• Output Compare Channels: 22
• Input Capture Channels: 22
• Pwm Channels: 22
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

15.4
8077H–AVR–12/09
Dead Time Insertion
The Dead Time Insertion (DTI) unit enables generation of “off” time where both the non-inverted
Low Side (LS) and inverted High Side (HS) of the WG output is low. This “off” time is called
dead-time, and dead-time insertion ensure that the LS and HS does not switch simultaneously.
The DTI unit consists of four equal dead time generators, one for each of the capture or com-
pare channel in Timer/Counter 0.
time generator. The dead time registers that define the number of peripheral clock cycles the
dead time is going to last, are common for all four channels. The High Side and Low Side can
have independent dead time setting and the dead time registers are double buffered.
Figure 15-3. Dead Time Generator block diagram
As shown in
one for each peripheral clock cycle until it reaches zero. A non-zero counter value will force both
the Low Side and High Side outputs into their “off” state. When a change is detected on the WG
output, the Dead Time Counter is reloaded with the DTx register value according to the edge of
the input. Positive edge initiates a counter reload of the DTLS Register and a negative edge a
reload of DTHS Register.
WG output
Dead Time Generator
Figure 15-4 on page
D
Q
Edge Detect
V
Figure 15-3 on page 179
180, the 8-bit Dead Time Counter (dti_cnt) is decremented by
DTLSBUF
DTILS
LOAD
E
V
shows the block diagram of one dead
Counter ("dti_cnt")
DTHSBUF
= 0
DTIHS
XMEGA A
"dtls"
(To PORT)
"dths"
(To PORT)
179