AT90USB162 Atmel Corporation, AT90USB162 Datasheet - Page 205

• Manufacturer Part Number: AT90USB162
• Manufacturer: Atmel Corporation

Specifications of AT90USB162

• Flash (kbytes): 16 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 22
• Ext Interrupts: 21
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 5
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

20.14.1
20.14.1.1
7707F–AVR–11/10
Example with 1 IN data bank
Detailed description
Example with 2 IN data banks
FIFOCON
FIFOCON
TXINI
TXINI
Abort
SW
SW
write data from CPU
write data from CPU
The RWAL bit always reflects the state of the current bank. This bit is set if the firmware can
write data to the bank, and cleared by hardware when the bank is full.
The data are written by the CPU, following the next flow:
If the endpoint uses 2 banks, the second one can be read by the HOST while the current is
being written by the CPU. Then, when the CPU clears FIFOCON, the next bank may be already
ready (free) and TXINI is set immediately.
An “abort” stage can be produced by the host in some situations:
• When the bank is empty, an endpoint interrupt (EPINTx) is triggered, if enabled (TXINE set)
• The CPU acknowledges the interrupt by clearing TXINI,
• The CPU can write the data into the current bank (write in UEDATX),
• The CPU can free the bank by clearing FIFOCON when all the data are written, that is:
• after “N” write into UEDATX
• as soon as RWAL is cleared by hardware.
NAK
BANK 0
and TXINI is set. The CPU can also poll TXINI or FIFOCON, depending the software
architecture choice,
BANK 0
SW
SW
IN
IN
SW
write data from CPU
BANK 1
(bank 0)
(bank 0)
DATA
DATA
SW
HW
HW
ACK
ACK
SW
SW
write data from CPU
write data from CPU
IN
BANK 0
BANK0
AT90USB82/162
(bank 1)
DATA
SW
IN
ACK
205