PEB 3086 F V1.4 Infineon Technologies, PEB 3086 F V1.4 Datasheet - Page 107

• Manufacturer Part Number: PEB 3086 F V1.4
• Description: IC ISDN ACCESS CTRLR TQFP64
• Manufacturer: Infineon Technologies
• Series: ISAC™r

Specifications of PEB 3086 F V1.4

• Function: Subscriber Access Controller
• Interface: HDLC, IOM-2, ISDN, Parallel, SCI
• Number Of Circuits: 1
• Voltage - Supply: 3.3V
• Current - Supply: 30mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 64-LFQFP
• Includes: D-Channel Access Control and Priority Handler, Monitor Channel Handler, Non-Auto Mode, Transparent Mode
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power (watts): -
• Other names: PEB3086FV1.4XT; PEB3086FV14NP; PEB3086FV14XP; SP000007571; SP000007572

Example:
w CDA1_CR = 00
w CDA10 = 5A
r CDA10 = FF
w CDA1_CR = 02
r CDA10 = 5A
3.7.2
For time slot oriented standard devices connected to the IOM-2 interface the ISAC-SX
provides two independent data strobe signals SDS1 and SDS2. Instead of a data strobe
signal a strobed IOM-2 bit clock can be provided on pin SDS1 and SDS2.
3.7.2.1
The two strobe signals can be generated with every 8-kHz frame and are controlled by
the registers SDS1/2_CR. By programming the TSS bits and three enable bits
(ENS_TSS, ENS_TSS+1, ENS_TSS+3) a data strobe can be generated for the IOM-2
time slots TS, TS+1 and TS+3 and any combination of them.
The data strobes for TS and TS+1 are always 8 bits long (bit7 to bit0) whereas the data
strobe for TS+3 is always 2 bits long (bit7, bit6).
Figure 56
SDS is active during channel B2 on IOM-2 whereas in the second example during IC2
and MON1. The third example shows a strobe signal for 2B+D channels which can be
used e.g. for an IDSL (144kbit/s) transmission.
Data Sheet
shows three examples for the generation of a strobe signal. In example 1 the
Serial Data Strobe Signal and Strobed Data Clock
Serial Data Strobe Signal
H
H
H
(old value of previous programming)
(the programmed value can be read back)
(example)
H
H
(inputs and outputs are disabled)
(output of CDA10 is enabled)
107
Description of Functional Blocks
PEB 3086
2003-01-30
ISAC-SX