ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 96

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

10
11
12
13
14
15
16
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive e.g. GROUND and power rails
N/C - Not connected
Please note:
Signal GROUND (0V)
The ‘Signal GROUND (0V)’ connection is the 0V to which the programming lines (JTAG, SPI, I2C,
UART) are referenced to. This 0V line should be connected directly to the Target System (UUT) 0V
connection via the shortest possible wire link.
Target Vcc
The ‘Target Vcc’ is the output of the ‘Controlled Power Supply’ from the programmer. The power
supply has a range of 1.8 to 5.0V and can be switched ON / OFF to the Target System under
programmer control.
80
Programmer I/O5
Programmer I/O4
Programmer I/O3
Programmer I/O2
Programmer I/O1
PROG_VPP
PROG_RESET
I/O
I/O
I/O
I/O
I/O
P
O
ISPnano Series Programmer - User Manual – V1.11 – 12
Spare I/O
See note
RESET
•
•
•
•
•
•
•
•
•
JTAG – TMS This pin is used for JTAG Target
JTAG – TCK
SPI - SCK
JTAG – TDO
SPI – MISO
UART - RXD
JTAG – TDI
SPI – MOSI
UART - TXD
Systems only.
This pin can be used for JTAG or
SPI Target Systems.
This pin can be used for JTAG, SPI
or UART Target Systems.
This pin can be used for JTAG, SPI
or UART Target Systems.
Vpp Voltage
The programmer can output a “Vpp”
voltage on this pin between 6.5V
and 13.8V. This pin should not be
connected unless a Vpp voltage is
required by the Target IC.
Target RESET control pin
This pin controls the Target Device
RESET pin. It will driven
HIGH/LOW according to the device
type and settings in the <Pre-
program State Machine> tab in the
EQtools project.
th
May 2011