ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 122

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

2.2 Power Supply connections
The ‘ISPnano Series 3 ATE’ programmer requires a separate +12V power supply to power the
RELAY coils.
Instructions:
2.3 Programmer Power Supply recommendations
The ‘DC-IN’ connector is used to supply power to the internal programmer electronics. If the
programmer is not powering the Target System, then the programmer will only draw around 150mA
@ 9.0V. However, if the ‘Programmer controlled Target Power Supply’ is enabled, then the
programmer will also supply power to the Target System which could take a significant amount of
current. It is therefore recommended that a suitable power supply capable of supplying at least
500mA on load is used.
Although the ‘DC-IN’ connector is rated for any voltage from 9.0V to 24.0V, it is recommended where
possible to use 12.0V instead of 24.0V. In the event of a short circuit or other problem, the
programmer over-voltage protection will better protect the internal electronics if the supply voltage is
only 12.0V.
106
Programmer Power Supply
+9.0V to +24.0V @ 150mA
min
•
•
Connect a +9.0V to +24.0V power supply to the ‘DC IN’ connector.
Connect a +12.0V regulated power supply to the ‘DC EXT’ connector.
RELAY Coil Power Supply
+12.0V @ 250mA min
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011