ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 117

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

1.3 Target System routed to External ATE System (default)
When the programmer is powered up but not running a ‘Programming Project’, the relay coils are
not energised so the ‘Target System (UUT)’ connections are routed via the ‘Target ISP Port’,
through the relays to the ‘Target ISP Port’ where they then connect to the ‘External ATE System’.
The signal direction depends on the particular signal I/O line, GROUND or power line being routed.
The path of a single signal or passive power / GROUND line is shown in the schematic below.
Please note:
ISPnano Series Programmer - User Manual – V1.11 – 12
•
•
When the relays are not energised, the programmer electronics are completely isolated from
both the ‘Target System’ and the ‘External ATE System’.
This is the default state when the programmer is powered OFF or when it is powered ON and
the ‘EXT-VCC’ switch is OFF.
Target System
th
May 2011
Test / Control
External
or other
System
ATE
101