ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 49

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

2.7 Standalone Remote I/O Programmer Control
2.7.1 Overview
The ISPnano programmer can be controlled using a simple 4-wire Remote I/O (TTL) signalling
protocol as shown in the diagram below. This control method is ideal for interfacing the programmer
to In-Circuit Testers (ICT’s) or other production equipment which does not have an RS-232 port.
Fig. 2.8.1 Remote System Control of Programmer
START
Equinox
ACTIVE
Remote
PPM3
System
Programming
Module
OK
FAIL
GROUND
The Remote System simply asserts the programmer <START> signal to initiate the execution of a
‘Programming Project’. The programmer will then assert the <ACTIVE> signal to indicate that it has
commenced programming. At the end of the Programming operation the programmer asserts either
the <OK> or <FAIL> signal depending on the outcome. The Remote System must then de-assert the
<Start> signal to allow the programmer to reset ready to program the next device.
Please refer to section 2.8.3 for an example of the Remote I/O control signal waveforms for a typical
programming iteration.
th
ISPnano Series Programmer - User Manual – V1.11 – 12
May 2011
33