ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 76

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

4.4 Programmer Controlled ‘Target Vcc (TVCC) Power Supply’
The ‘Programmer controlled Target Vcc Power Supply’ is a very accurate user-programmable
power supply which has been designed to be able to provide controlled power to most Target
Systems (UUTs) which require a voltage between 1.8 and 5.0V. This power supply also features
‘target current monitoring’ so a current-limit can be set up to automatically shut down the power
supply in the event of a short-circuit.
Power supply features:
60
•
•
•
•
•
•
•
•
•
•
•
•
•
User programmable power supply – user can set up both Voltage and Current settings
The power supply can switch 1.2 to 5.0V @ 480mA to the Target System (UUT)
The power supply also generates the ‘Programmer Line Driver Voltage’ which sets the
Target I/O signal levels.
The voltage is output on the ‘TVCC’ pin of the programmer
Voltage accuracy: +/- 1% using factory calibrated voltages
Voltage accuracy: +/- 20 mV is possible at user-defined ‘spot calibrated’ voltages
Fast voltage slew-rate on switch-on
Power supply ‘Voltage measurement’ and ‘Target Voltage validation’ (checks that target
voltage is within pre-set limits)
User-definable ‘voltage stabilisation’ settings before / after target switch on
Target Voltage can also be measured if the programmer is not supplying power
Power supply by source up to 2 Amps continuously (before going into current limit) allowing it
to charge up the ‘target system capacitance’ at high speed
Target current monitoring with over-current detection at switch on
User-definable current stabilisation settings before / after target switch on
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011