ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 45

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

2.4 Programmer Operating Modes
The ISPnano programmer can be controlled in various different ways as detailed in the table below:
# Programmer Mode
1 Development Mode
2 Standalone -
3 Standalone -
4 Standalone -
5 Target System
ISPnano Series Programmer - User Manual – V1.11 – 12
Keypad Mode
ASCII Text
Communications
Control
4-Wire TTL Control
auto-detect mode
Control
Software
EQTools -
EDS
None
Any Terminal
Emulation
Software
None
None
U/
S
S In this mode, the programmer is controlled
S In this mode, the programmer is not
S This protocol can be used to control an
S The programmer can be controlled using a
S The programmer is capable of automatically
Functional description
by EQTools - Equinox Development Suite
(EDS). EDS allows you to read/write the
target device FLASH / EEPROM / FUSE /
LOCK bits interactively under PC control
without uploading a ‘Programming Project’
to the programmer.
connected to a PC and can program a
single ‘Programming Project’ into the
Target Device when the <START> key is
pressed. (A valid project must have been
previously uploaded to the programmer
using EQTools – Upload Wizard.)
Equinox programmer from a Remote
Application or Remote System using a
simple set of ASCII serial commands. This
protocol is ideal for controlling Equinox
programmers from any Remote System
which features an RS-232 serial port and
which can operate at a fixed baud rate of
38,400.
4-wire TTL signalling protocol as shown in
the diagram below. This control method is
ideal for interfacing the programmer In-
Circuit Testers (ICT’s) or other production
equipment which does not have an RS-232
port.
detecting when a Target System is
connected to / disconnected from the
programmer. This can be used to trigger the
execution of a Programming Project in
Standalone Mode.
th
May 2011
Refer
to
section
2.5
2.6
2.7
2.8
2.9
29