XW2Z-200J-B1 Omron, XW2Z-200J-B1 Datasheet - Page 329

• Manufacturer Part Number: XW2Z-200J-B1
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB1

Note The present value of TIM, TIMH(015), and TMHH(540) timers programmed will be updated even when
Counter Area
Note It is not recommended to use the same counter number in two counter instructions because the
306
I/O Memory
The following table shows when timer PVs and Completion Flags will be reset.
jumped between JMP and JME instructions.
The 256 counter numbers (C0000 to C0255) are shared by the CNT and CNTR(012) instructions.
Counter Completion Flags and present values (PVs) for these instructions are accessed with the
counter numbers.
When a counter number is used in an operand that requires bit data, the counter number accesses the
Completion Flag of the counter. When a counter number is used in an operand that requires word data,
the counter number accesses the PV of the counter.
counters will not operate correctly if they are counting simultaneously. If two or more counter instructions
use the same counter number, an error will be generated during the program check, but the counters will
operate as long as the instructions are not executed in the same cycle.
The following table shows when counter PVs and Completion Flags will be reset.
Counter Completion Flags can be force-set and force-reset.
Counter PVs cannot be force-set or force-reset, although the PVs can be refreshed indirectly by force-
setting/resetting the Completion Flag.
There are no restrictions in the order of using counter numbers or in the number of NC or NO conditions
that can be programmed. Counter PVs can be read as word data and used in programming.
TIMER: TIM
HIGH-SPEED TIMER:
TIMH(015)
ONE-MS TIMER:
TMHH(540)
COUNTER: CNT
REVERSIBLE
COUNTER: CNTR(012)
Instruction
Instruction
PV → 0
Flag → OFF
Flag → OFF
PROGRAM and
PV → 0000
RUN/MONITOR
Mode change
between
Reset
Maintained
PROGRAM and
RUN/MONITOR
Mode change
PV → 0
Flag → OFF
FQM1 startup
between
Reset
PVs refreshed in operat-
ing timers
(JMP-JME) or tasks on
Operation in jumps
startup
FQM1
standby
Reset
At reset input
PV → SV
(Reset to SV.)
Flag → OFF
Operation in interlocks
(IL-ILC)
Appendix B
Maintained
interlocks (IL-
Operation in
ILC)