DP83840AVCE National Semiconductor, DP83840AVCE Datasheet - Page 69

• Manufacturer Part Number: DP83840AVCE
• Description: IC ETHERNET PHYS LAYER 100-PQFP
• Manufacturer: National Semiconductor

Specifications of DP83840AVCE

• Controller Type: Ethernet Controller, 10Base-T
• Interface: IEEE 802.3af
• Voltage - Supply: 4.75 V ~ 5.25 V
• Current - Supply: 335mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 100-MQFP, 100-PQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: *DP83840AVCE

Version A
7.0 Hardware User Information
Description:
The DP83840A when in 10 Mb/s Repeater Mode does not
conform to 802.3 IEEE specification for Carrier Sense
(CRS). The specification states that CRS becomes active
whenever the receive input becomes active and in-active
when there is no activity. The DP83840A uses its’ internal
Phase Lock Loop (PLL) to gate CRS. This causes CRS to
glitch when the PLL switches from Receive mode to
Transmit mode and when the PLL switches from Transmit
to Receive mode. The switching of modes is what occurs
during collisions.
Symptoms:
When the part is receiving a packet and then TX_EN is
asserted, CRS will glitch twice, once following the rising
edge of TX_EN and once following the end of RXI+/-. This
is illustrated in Figure 27.
RXI +/-
CRS
TX_EN
FIGURE 27. CRS Glitching
(Continued)
69
When the part receives a JAM signal that has a
combination of 5 MHz and 10 MHz signals, CRS will glitch.
CRS behaves normally when a 101010... JAM pattern is
received. All repeaters and most MACs send out 101010...
JAM signals, but there are a few MACs that will send out
pseudo-random 5/10 MHz data.
Solution/Workaround:
Putting the part into Full-Duplex mode eliminates the CRS
glitching problem. However, when the part is in Full-Duplex
mode the COL pin (pin 65) will not indicate if collisions
have occurred.
National Semiconductor