LAN9420I-NU SMSC, LAN9420I-NU Datasheet - Page 33

• Manufacturer Part Number: LAN9420I-NU
• Description: IC ETHERNET CTRLR SGL 128VTQFP
• Manufacturer: SMSC
• Type: Single Chip MAC and PHY Controllerr

Specifications of LAN9420I-NU

• Controller Type: Ethernet Controller
• Interface: PCI
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 145mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 128-TQFP, 128-VQFP
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: 802.3, 802.3u
• Data Rate: 10 MB, 100 MB
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 1.6 V
• Maximum Operating Temperature: + 85 C
• Ethernet Connection Type: 10/100 Base-T
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1085

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
SMSC LAN9420/LAN9420i
3.3.5.3.1
Note: The EEPROM device powers-up in the erase/write disabled state. To modify the contents of
If an operation is attempted, and an EEPROM device does not respond within 30mS,
LAN9420/LAN9420i will timeout, and the EPC Time-out bit (EPC_TO) in the E2P_CMD register will be
set.
Figure 3.7
The Host can disable the EEPROM interface through the GPIO_CFG register. When the interface is
disabled, the EEDIO and ECLK signals can be used as general-purpose outputs, or they may be used
to monitor internal MII signals.
SUPPORTED EEPROM OPERATIONS
The EEPROM controller supports the following EEPROM operations under Host control via the
E2P_CMD register. The operations are commonly supported by “93C46” EEPROM devices. A
description and functional timing diagram is provided below for each operation. Please refer to the
E2P_CMD register description in
page 99
ERASE (Erase Location): If erase/write operations are enabled in the EEPROM, this command will
erase the location selected by the EPC Address field (EPC_ADDR). The EPC_TO bit is set if the
EEPROM does not respond within 30ms.
Busy Bit = 0
the EEPROM, the Host must first issue the EWEN command.
for E2P_CMD field settings for each command.
illustrates the Host accesses required to perform an EEPROM Read or Write operation.
EEPROM Write
Figure 3.7 EEPROM Access Flow Diagram
Write Data
Command
Command
Register
Register
Register
Read
Write
Idle
DATASHEET
Section 4.2.11, "EEPROM Command Register (E2P_CMD)," on
33
EEPROM Read
Read Data
Command
Command
Register
Register
Register
Read
Write
Idle
Busy Bit = 0
Revision 1.4 (12-17-08)