ST72F324BK6TAS STMicroelectronics, ST72F324BK6TAS Datasheet - Page 132

• Manufacturer Part Number: ST72F324BK6TAS
• Description: 8-BIT MCU
• Manufacturer: STMicroelectronics

On-chip peripherals
10.6.3
Note:
132/198
Functional description
The conversion is monotonic, meaning that the result never decreases if the analog input
does not increase.
If the input voltage (V
conversion result is FFh in the ADCDRH register and 03h in the ADCDRL register (without
overflow indication).
If the input voltage (V
conversion result in the ADCDRH and ADCDRL registers is 00 00h.
The A/D converter is linear and the digital result of the conversion is stored in the ADCDRH
and ADCDRL registers. The accuracy of the conversion is described in the Electrical
Characteristics Section.
R
is too high, this will result in a loss of accuracy due to leakage and sampling not being
completed in the allotted time.
A/D converter configuration
The analog input ports must be configured as input, no pull-up, no interrupt. Refer to
Section 9: I/O
to be read as a logic input.
In the ADCCSR register:
Starting the conversion
In the ADCCSR register:
When a conversion is complete:
●
●
A read to the ADCDRH resets the EOC bit.
To read the 10 bits, perform the following steps:
1.
2.
3.
The data is not latched, so both the low and the high data register must be read before the
next conversion is complete. Therefore, it is recommended to disable interrupts while
reading the conversion result.
To read only 8 bits, perform the following steps:
1.
2.
AIN
Select the CS[3:0] bits to assign the analog channel to convert.
Set the ADON bit to enable the A/D converter and to start the conversion. From this
time on, the ADC performs a continuous conversion of the selected channel.
the EOC bit is set by hardware
the result is in the ADCDR registers
Poll the EOC bit.
Read the ADCDRL register
Read the ADCDRH register. This clears EOC automatically.
Poll the EOC bit.
Read the ADCDRH register. This clears EOC automatically.
is the maximum recommended impedance for an analog input signal. If the impedance
ports. Using these pins as analog inputs does not affect the ability of the port
AIN
AIN
) is greater than V
) is lower than V
Doc ID13466 Rev 4
SSA
AREF
(low-level voltage reference) then the
(high-level voltage reference) then the
ST72324B-Auto