750-841 WAGO, 750-841 Datasheet - Page 82

• Manufacturer Part Number: 750-841
• Description: CONTR.ETHERNET TCP/IP 10/100MBIT
• Manufacturer: WAGO

Specifications of 750-841

• Rohs Compliant: YES
• No. Of Digital Inputs: 10
• No. Of Digital Outputs: 10

74 •
3.1.7.2.6 Deactivating the BootP Protocol
Fieldbus Controller
Fieldbus Controller 750-841
1. Disabling of the BootP protocol is done via the built-in web pages stored in
2. Now enter the controller’s I/P address in the address box of the browser and
3. One of the controller’s built-in web pages is displayed. The opening page
4. When the test has been performed successfully, you can close the DOS
5. Since the IP address is still temporarily stored in the controller. Do not
By default, the BootP protocol is activated in the controller.
When the BootP protocol is activated, the controller expects the
permanent presence of a BootP server. If, however, there is no BootP
server available at a power-on reset, the PFC’s network remains inactive.
To operate the controller with the IP configuration stored in the EEPROM, the
BootP protocol must be deactivated.
Note
If the BootP protocol is disabled after the IP address assignment, the stored
IP address is retained even after power is removed from your controller.
prompt.
cycle power on the controller until the BootP protocol has been disabled in
the PFC.
the controller. Open a web browser on your PC (e.g., Microsoft Internet
Explorer).
press the Enter key.
displays information about your fieldbus controller. Click the Port
hyperlink on the left navigation bar.
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP