IDT92HD81B1X5NLGXYCX8 IDT, Integrated Device Technology Inc, IDT92HD81B1X5NLGXYCX8 Datasheet - Page 45

• Manufacturer Part Number: IDT92HD81B1X5NLGXYCX8
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of IDT92HD81B1X5NLGXYCX8

• Lead Free Status / RoHS Status: Compliant

92HD81
SINGLE CHIP PC AUDIO SYSTEM, CODEC+SPEAKER AMPLIFIER+CAPLESS HP+LDO
©2009 INTEGRATED DEVICE TECHNOLOGY, INC.
IDT™ CONFIDENTIAL
2.Ratio of Full Scale signal to idle channel noise output is measured “A weighted” over a 20 Hz to a 20 kHz bandwidth.
(AES17-1991 Idle Channel Noise or EIAJ CP-307 Signal-to-noise Ratio).
3.THD+N ratio as defined in AES17 and outlined in AES6id,non-weighted, over 20 Hz to 20 kHz bandwidth.Results at the jack
are dependent on external components and will likely be 1 - 2dB worse.
4.Peak-to-Peak Ripple over Passband meets ± 0.125dB limits, 48 kHz or 44.1 kHz Sample Frequency. 1dB limit.
5.Peak-to-Peak Ripple over Passband meets ± 0.125dB limits, 48 kHz or 44.1 kHz Sample Frequency. 1dB limit.
6.Stop Band rejection determines filter requirements. Out-of-Band rejection determines audible noise.
7.The integrated Out-of-Band noise generated by the DAC process, during normal PCM audio playback, over a bandwidth 28.8
to 100 kHz, with respect to a 1 Vrms DAC output.
8.± 1dB limits for Line Output & 0 dB gain, at -20dBV
9.Spurious tone rejection is tested with ADC dither enabled and compared to ADC performance without dither.
10.All functions/converters active, pin complexes enabled, two FDX streams, line (10Kohm) loads. Add 24mA analog current per
stereo 32 ohm headphone.
11.One stereo DAC and corresponding pin widgets enabled (playback mode)
12.Mixer enabled
13.Idle measurement D3 set for minimum clicks/pops (biases and min. amps. on)
14.Can be set to 0.5 or 0.8 AVdd.
45
V 0.987 11/09
92HD81