600880 Tyco Electronics, 600880 Datasheet - Page 67

• Manufacturer Part Number: 600880
• Description: Connector Accessories Hand Tool Left Die Set
• Manufacturer: Tyco Electronics
• Type: Die Setr

Applicators
Dimensions are in inches and
Dimensions are in inches and
millimeters unless otherwise
millimeters unless otherwise
specified. Values in brackets
specified. Values in brackets
are metric equivalents.
are metric equivalents.
Magnet Wire Terminals and Termination Systems
AMPLIVAR and Cluster Blocks Application Tooling
Dimensions are shown for
Dimensions are shown for
reference purposes only.
reference purposes only.
Specifications subject to change.
Specifications subject to change.
End- and Side-Feed
Heavy-Duty Miniature
(HDM) Applicators
AMP applicators are
designed to exacting
specifications to produce
consistent, high-quality
terminations.
HDM applicators are
quickly interchangeable
and easily repaired. They
feature simple dial-in
settings for adjusting crimp
height for terminating differ-
ent wire combinations within
the designated CMA range.
Standard (STD)
Applicators
Standard style applicators
are generally used for long
production runs using
dedicated equipment, or
when splicing a coil, for
example, that needs to be
positioned close to the
crimping area in the
applicator. The crimp height
can be adjusted by raising
or lowering the base mount.
Standard Style Applicator for
Large CMA Splice,
Part Number 566372-2
This applicator was
designed specifically to
apply AMP 5 000-16 000
CMA Splice, Part Number
63625-1. It features a
highly-visible, close-up
crimp area—less than 1
[25] from the front of the
guard. You can easily
splice multiple wires by
Technical Support
Technical Support
USA: 1-800-522-6752
USA: 1-800-522-6752
Canada: 1-905-475-6222
Canada: 1-905-475-6222
Mexico: 01-800-733-8926
Mexico: 01-800-733-8926
(Continued)
These applicators are used
with both bench machines
and fully-automatic lead
makers. They can also be
used for crimp quality
monitoring on systems
equipped with the CQM
G-Adapter. Call the AMP
Tooling Assistance Center
at 1-800-722-1111 for
further information.
simply rotating them down
through the front of the
guard into the crimp area.
It is an air-feed applicator,
and can be used with
Model “K” Part Number
1-471273-3.
www.tycoelectronics.com
www.tycoelectronics.com
Catalog 82221
Revised 10-02
67