600880 Tyco Electronics, 600880 Datasheet - Page 31

• Manufacturer Part Number: 600880
• Description: Connector Accessories Hand Tool Left Die Set
• Manufacturer: Tyco Electronics
• Type: Die Setr

SIAMEZE
Interconnection System
How the System Operates
Dimensions are in inches and
millimeters unless otherwise
specified. Values in brackets
are metric equivalents.
Magnet Wire Terminals and Termination Systems
SIAMEZE Terminals
Test Results
Standard Range SIAMEZE
products have been
submitted to the following
tests without significant
millivolt increase:
Trim Blade
The trim blade cuts the
excess magnet wire and
the wire cutoff block at
the front of the cavity.
Terminal Insertion
Finger
The terminal insertion
finger is part of the
SIAMEZE Inserter. It
pushes the terminal that
was sheared from the
carrier strip through the
“tube” into the cavity.
Contact
Various wire attachments
in standard, fine, medium
and heavy duty terminals
are available (See tables).
IDC Slot
The IDC slot in the
terminal will terminate a
wide range of magnet
wire sizes.
Stripping Burrs
During the insertion
process, these burrs
strip the film insulation
from the magnet wire.
Locking Barbs
Terminal retention is
provided in the cavity by
single or multiple locking
barbs.
Dimensions are shown for
reference purposes only.
Specifications subject to change.
(Continued)
Current Cycling —
50 cycles with each cycle
consisting of 15 minutes
“ON” followed by 15
minutes “OFF”
Thermal Shock —
10 cycles with each cycle
consisting of 30 minutes at
150°C followed by 30
minutes at 21°C
Humidity —
Temperature Cycling
10 cycles between 25°C
and 65°C at 80 to 100% RH
11
Terminal Insertion
Complete
The magnet wire
termination is complete
when the terminal is fully
seated in the cavity.
Plastic Cavity
Production has to be
in accordance with
Tyco Electronics
specifications (for cavity
drawing numbers see
tables). Consulting
Tyco Electronics is
required for design in.
Cavity Slot for Wire
The width has to be in
accordance with the wire
size (see cavity
drawings).
Magnet Wire
The magnet wire is
positioned in “U” slot
manually or automatically
by coil winding
equipment.
Wire Cutoff Block
The wire cutoff block
supports the magnet
wire during the trimming
process. The magnet
wire is cut plain to the
cavity front side.
Technical Support
USA: 1-800-522-6752
Canada: 1-905-475-6222
Mexico: 01-800-733-8926
11
www.tycoelectronics.com
Catalog 82221
Revised 10-02
31