ATMEGA32M1-AUR Atmel, ATMEGA32M1-AUR Datasheet - Page 298

• Manufacturer Part Number: ATMEGA32M1-AUR
• Description: IC MPU AVR 32K 20MHZ 32TQFP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA32M1-AUR

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: CAN, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, Temp Sensor, WDT
• Program Memory Size: 32KB (16K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 11x10b; D/A 1x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-TQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of I /o: -

27.9.7
27.9.8
27.9.9
27.9.10
298
ATmega16M1/32M1/64M1
Reading the EEPROM
Programming the Fuse Low Bits
Programming the Fuse High Bits
Programming the Extended Fuse Bits
The algorithm for reading the EEPROM memory is as follows (refer to
on page 295
The algorithm for programming the Fuse Low bits is as follows (refer to
on page 295
The algorithm for programming the Fuse High bits is as follows (refer to
Flash” on page 295
The algorithm for programming the Extended Fuse bits is as follows (refer to
Flash” on page 295
1. A: Load Command “0000 0011”
2. G: Load Address High Byte (0x00 - 0xFF)
3. B: Load Address Low Byte (0x00 - 0xFF)
4. Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA
5. Set OE to “1”
1. A: Load Command “0100 0000”
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit
3. Give WR a negative pulse and wait for RDY/BSY to go high
1. A: Load Command “0100 0000”
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit
3. Set BS1 to “1” and BS2 to “0”. This selects high data byte
4. Give WR a negative pulse and wait for RDY/BSY to go high
5. Set BS1 to “0”. This selects low data byte
1. A: Load Command “0100 0000”
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit
3. Set BS1 to “0” and BS2 to “1”. This selects extended data byte
4. Give WR a negative pulse and wait for RDY/BSY to go high
5. Set BS2 to “0”. This selects low data byte
for details on Command and Address loading):
for details on Command and Data loading):
for details on Command and Data loading):
for details on Command and Data loading):
“Programming the Flash”
“Programming the Flash”
“Programming the
“Programming the
8209D–AVR–11/10