UPD78F0513AGA-GAM-AX Renesas Electronics America, UPD78F0513AGA-GAM-AX Datasheet - Page 730

• Manufacturer Part Number: UPD78F0513AGA-GAM-AX
• Description: MCU 8BIT 48-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AGA-GAM-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 41
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

<R>
78K0/Kx2
27.6.3 RESET pin
reset signal generator on the board, signal collision takes place. To prevent this collision, isolate the connection with the
reset signal generator.
not be correctly programmed.
programmer.
27.6.4 Port pins
status as that immediately after reset. If external devices connected to the ports do not recognize the port status
immediately after reset, the port pin must be connected to EV
27.6.5 REGC pin
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
If the reset signal of the dedicated flash memory programmer is connected to the RESET pin that is connected to the
If the reset signal is input from the user system while the flash memory programming mode is set, the flash memory will
When the flash memory programming mode is set, all the pins not used for flash memory programming enter the same
Note With products without an EV
Connect the REGC pin to V
V
DD
.
microcontrollers
78K0/Kx2
RESET
SS
via a capacitor (0.47 to 1
Do not input any signal other than the reset signal of the dedicated flash memory
In the flash memory programming mode, the signal output by the reset
signal generator collides with the signal output by the dedicated flash
memory programmer. Therefore, isolate the signal of the reset signal
generator.
Figure 27-9. Signal Collision (RESET Pin)
SS
Signal collision
pin, connect them to V
μ
Reset signal generator
F) in the same manner as during normal operation.
DD
Dedicated flash memory
programmer connection signal
Note
Output pin
SS
or EV
. With products without an EV
SS
Note
via a resistor.
CHAPTER 27 FLASH MEMORY
DD
pin, connect them to
730