HD6417034AFI20V Renesas Electronics America, HD6417034AFI20V Datasheet - Page 81

• Manufacturer Part Number: HD6417034AFI20V
• Description: MCU 5V 0K I-TEMP PB-FREE 112-QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7030r

Specifications of HD6417034AFI20V

• Core Processor: SH-1
• Core Size: 32-Bit
• Speed: 20MHz
• Connectivity: EBI/EMI, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 32
• Program Memory Type: ROMless
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 112-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

4.1.2
Exception sources are detected at the times indicated in table 4.1, whereupon handling starts.
Table 4.1
Exception Type
Reset
Address error
Interrupt
Instruction
When exception handling begins, the CPU operates as follows:
Resets: The initial values of the program counter (PC) and stack pointer (SP) are read from the
exception vector table (the respective PC and SP values are H'00000000 and H'00000004 for a
power-on reset and H'00000008 and H'0000000C for a manual reset). For more information on the
exception vector table, see section 4.1.3, Exception Vector Table. Next, the vector base register
(VBR) is cleared to zero and interrupt mask bits (I3–I0) in the status register (SR) are set to 1111.
Program execution starts from the PC address read from the exception vector table.
Address Errors, Interrupts and Instructions: SR and PC are pushed onto the stack indicated in
R15. For interrupts, the interrupt priority level is written in the interrupt mask bits (I3–I0). For
address errors and instructions, bits I3–I0 are not affected. Next, the start address is fetched from
the exception vector table, and program execution starts from this address.
Exception Handling Operation
Power-on
Manual
Trap instruction Starts when a trap instruction (TRAPA) is executed.
General illegal
instruction
Illegal slot
instruction
Exception Source Detection and Start of Handling
Source Detection and Start of Handling
Low-to-high transition at RES pin when NMI is high
Low-to-high transition at RES pin when NMI is low
instruction that was executing prior to this point is completed.
instruction that was executing prior to this point is completed.
Starts when undefined code is decoded at a position other than
directly after a delayed branch instruction (a delay slot).
Starts when undefined code or an instruction that rewrites the PC
is decoded directly after a delayed branch instruction (in a delay
slot).
Detected when instruction is decoded and starts after the
Detected when instruction is decoded and starts after the
Rev. 7.00 Jan 31, 2006 page 53 of 658
Section 4 Exception Handling
REJ09B0272-0700