ST72F63BK4M1 STMicroelectronics, ST72F63BK4M1 Datasheet - Page 118
![IC MCU 8BIT LS 16K 34-SOIC](/photos/12/15/121510/497-34-soic_series_sml.jpg)
ST72F63BK4M1
Manufacturer Part Number
ST72F63BK4M1
Description
IC MCU 8BIT LS 16K 34-SOIC
Manufacturer
STMicroelectronics
Series
ST7r
Datasheet
1.ST72F63BD6U1TR.pdf
(186 pages)
Specifications of ST72F63BK4M1
Core Processor
ST7
Core Size
8-Bit
Speed
8MHz
Connectivity
I²C, SCI, USB
Peripherals
DMA, LVD, POR, PWM, WDT
Number Of I /o
19
Program Memory Size
16KB (16K x 8)
Program Memory Type
FLASH
Ram Size
512 x 8
Voltage - Supply (vcc/vdd)
4 V ~ 5.5 V
Data Converters
A/D 8x8b
Oscillator Type
Internal
Operating Temperature
0°C ~ 70°C
Package / Case
34-SOIC (7.5mm Width)
Processor Series
ST72F6x
Core
ST7
Data Bus Width
8 bit
Data Ram Size
512 B
Interface Type
I2C, SCI, USB
Maximum Clock Frequency
8 MHz
Number Of Programmable I/os
27
Number Of Timers
2 x 16 bit
Operating Supply Voltage
4 V to 5.5 V
Maximum Operating Temperature
+ 70 C
Mounting Style
SMD/SMT
Development Tools By Supplier
ST7MDTU3-EPB/US, ST72F63B-SK/RAIS, ST7MDTU3-EMU3, STX-RLINK
Minimum Operating Temperature
0 C
On-chip Adc
8 bit
For Use With
497-5521 - EVAL BOARD LOW SPEED USB
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Eeprom Size
-
Lead Free Status / Rohs Status
Details
Other names
497-2115-5
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ST72F63BK4M1
Manufacturer:
ST
Quantity:
20 000
On-chip peripherals
118/186
2 ACK Acknowledge enable.
1 STOP Generation of a Stop condition.
0 ITE Interrupt enable.
This bit is set and cleared by software. It is also cleared by hardware when the
interface is disabled (PE=0).
0: No acknowledge returned
1: Acknowledge returned after an address byte or a data byte is received
This bit is set and cleared by software. It is also cleared by hardware in master
mode. Note: This bit is not cleared when the interface is disabled (PE=0).
In Master mode:
0: No stop generation
1: Stop generation after the current byte transfer or after the current Start condition
is sent. The STOP bit is cleared by hardware when the Stop condition is sent.
In Slave mode:
0: No stop generation
1: Release the SCL and SDA lines after the current byte transfer (BTF=1). In this
mode the STOP bit has to be cleared by software.
This bit is set and cleared by software and cleared by hardware when the interface
is disabled (PE=0).
0: Interrupts disabled
1: Interrupts enabled
Refer to
SCL is held low when the SB, BTF or ADSL flags or an EV6 event (See
is detected.
Figure 49
Doc ID 7516 Rev 8
for the relationship between the events and the interrupt.
ST7263Bxx
Figure
48)