AT32UC3A0128-ALUR Atmel, AT32UC3A0128-ALUR Datasheet - Page 222

• Manufacturer Part Number: AT32UC3A0128-ALUR
• Description: MCU AVR32 128K FLASH 144LQFP
• Manufacturer: Atmel
• Series: AVR®32 UC3r

Specifications of AT32UC3A0128-ALUR

• Core Processor: AVR
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: EBI/EMI, Ethernet, I²C, SPI, SSC, UART/USART, USB OTG
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 109
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.65 V ~ 1.95 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• Package: 144LQFP
• Device Core: AVR32
• Family Name: AT32
• Maximum Speed: 66 MHz
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 32 Bit
• Number Of Programmable I/os: 69
• Interface Type: Ethernet/I2S/JTAG/SPI/TWI/USART
• Number Of Timers: 3
• For Use With: ATEVK1105 - KIT EVAL FOR AT32UC3A0ATAVRONEKIT - KIT AVR/AVR32 DEBUGGER/PROGRMMR770-1008 - ISP 4PORT ATMEL AVR32 MCU SPIATEVK1100 - KIT DEV/EVAL FOR AVR32 AT32UC3A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

24.5
Figure 24-2. Application Block Diagram
24.6
Table 24-3.
24.7
24.7.1
24.7.2
32058J-AVR32-04/11
Pin Name
TWD
TWCK
Application Block Diagram
I/O Lines Description
Product Dependencies
I/O Lines
Power Management
I/O Lines Description
Rp: Pull up value as given by the I²C Standard
Host with
Interface
TWI
Both TWD and TWCK are bidirectional lines, connected to a positive supply voltage via a current
source or pull-up resistor (see
high. The output stages of devices connected to the bus must have an open-drain or open-col-
lector to perform the wired-AND function.
TWD and TWCK pins may be multiplexed with GPIO lines. To enable the TWI, the programmer
must perform the following steps:
• Program the GPIO controller to:
The TWI clock is generated by the Power Manager (PM). Before using the TWI, the programmer
must ensure that the TWI clock is enabled in the PM.
In the TWI description, Master Clock (MCK) is the clock of the peripheral bus to which the TWI is
connected.
TWD
TWCK
– Dedicate TWD and TWCK as peripheral lines.
– Define TWD and TWCK as open-drain.
Serial EEPROM
Pin Description
Two-wire Serial Data
Two-wire Serial Clock
Atmel TWI
Slave 1
I²C RTC
Slave 2
Figure 24-2 on page
Controller
I²C LCD
Slave 3
I²C Temp.
222). When the bus is free, both lines are
Slave 4
Sensor
Rp
Rp
AT32UC3A
VDD
Input/Output
Input/Output
Type
222