st92f120 STMicroelectronics, st92f120 Datasheet - Page 196

• Manufacturer Part Number: st92f120
• Description: 8/16-bit Flash Mcu Family With Ram, Eeprom And J1850 Blpd
• Manufacturer: STMicroelectronics

MULTIPROTOCOL SERIAL COMMUNICATIONS INTERFACE (SCI-M)
MULTIPROTOCOL SERIAL COMMUNICATIONS INTERFACE (Cont’d)
INTERRUPT MASK REGISTER (IMR)
R246 - Read/Write
Reset value: 0xx00000
Bit 7 = BSN: Buffer or shift register empty inter-
rupt .
This bit selects the source of the transmitter regis-
ter empty interrupt.
0: Select a Shift Register Empty as source of a
1: Select a Buffer Register Empty as source of a
Bit 6 = RXEOB: Received End of Block.
This bit is set by hardware only and must be reset
by software. RXEOB is set after a receiver DMA
cycle to mark the end of a data block.
0: Clear the interrupt request.
1: Mark the end of a received block of data.
Bit 5 = TXEOB: Transmitter End of Block.
This bit is set by hardware only and must be reset
by software. TXEOB is set after a transmitter DMA
cycle to mark the end of a data block.
0: Clear the interrupt request.
1: Mark the end of a transmitted block of data.
196/324
9
BSN
Transmitter Register Empty interrupt.
Transmitter Register Empty interrupt.
7
RXEOB TXEOB
RXE
RXA
RXB
RXDI
TXDI
0
Bit 4 = RXE: Receiver Error Mask.
0: Disable Receiver error interrupts (OE, PE, and
1: Enable Receiver error interrupts.
Bit 3 = RXA: Receiver Address Mask .
0: Disable Receiver Address interrupt (RXAP
1: Enable Receiver Address interrupt.
Bit 2 = RXB: Receiver Break Mask .
0: Disable Receiver Break interrupt (RXBP pend-
1: Enable Receiver Break interrupt.
Bit 1 = RXDI: Receiver Data Interrupt Mask .
0: Disable Receiver Data Pending and Receiver
1: Enable Receiver Data Pending and Receiver
Note: RXDI has no effect on DMA transfers.
Bit 0 = TXDI: Transmitter Data Interrupt Mask .
0: Disable Transmitter Buffer Register Empty,
1: Enable Transmitter Buffer Register Empty,
Note: TXDI has no effect on DMA transfers.
FE pending bits in the S_ISR register).
pending bit in the S_ISR register).
ing bit in the S_ISR register).
End of Block interrupts (RXDP and RXEOB
pending bits in the S_ISR register).
End of Block interrupts.
Transmitter Shift Register Empty, or Transmitter
End of Block interrupts (TXBEM, TXSEM, and
TXEOB bits in the S_ISR register).
Transmitter Shift Register Empty, or Transmitter
End of Block interrupts.