M55800A Atmel Corporation, M55800A Datasheet - Page 114

• Manufacturer Part Number: M55800A
• Manufacturer: Atmel Corporation

Specifications of M55800A

• Flash (kbytes): 0 Kbytes
• Pin Count: 176
• Max. Operating Frequency: 33 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 58
• Ext Interrupts: 58
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Uart: 3
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 72
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3/5.0
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

16.5
16.6
16.7
114
Interrupts
User Interface
Multi-driver (Open Drain)
AT91M5880A
selected whether the pin is used for its peripheral function or as a parallel I/O line. The register
PIO_IFSR (Input Filter Status) indicates whether or not the filter is activated for each pin.
Each parallel I/O can be programmed to generate an interrupt when a level change occurs. This
is controlled by the PIO_IER (Interrupt Enable) and PIO_IDR (Interrupt Disable) registers which
enable/disable the I/O interrupt by setting/clearing the corresponding bit in the PIO_IMR. When
a change in level occurs, the corresponding bit in the PIO_ISR (Interrupt Status) is set whether
the pin is used as a PIO or a peripheral and whether it is defined as input or output. If the corre-
sponding interrupt in PIO_IMR (Interrupt Mask) is enabled, the PIO interrupt is asserted.
When PIO_ISR is read, the register is automatically cleared.
Each individual I/O is associated with a bit position in the Parallel I/O user interface registers.
Each of these registers are 32 bits wide. If a parallel I/O line is not defined, writing to the corre-
sponding bits has no effect. Undefined bits read zero.
Each I/O can be programmed for multi-driver option. This means that the I/O is configured as
open drain (can only drive a low level) in order to support external drivers on the same pin. An
external pull-up is necessary to guarantee a logic level of one when the pin is not being driven.
Registers PIO_MDER (Multi-driver Enable) and PIO_MDDR (Multi-driver Disable) control this
option. Multi-driver can be selected whether the I/O pin is controlled by the PIO Controller or the
peripheral. PIO_MDSR (Multi-driver Status) indicates which pins are configured to support exter-
nal drivers.
1745F–ATARM–06-Sep-07