MT41J64M16LA-15E IT:B Micron Technology Inc, MT41J64M16LA-15E IT:B Datasheet - Page 111

• Manufacturer Part Number: MT41J64M16LA-15E IT:B
• Manufacturer: Micron Technology Inc
• Type: DDR3 SDRAMr

Specifications of MT41J64M16LA-15E IT:B

• Organization: 64Mx16
• Density: 1Gb
• Address Bus: 16b
• Maximum Clock Rate: 1.333GHz
• Operating Supply Voltage (typ): 1.5V
• Package Type: FBGA
• Operating Temp Range: -40C to 95C
• Operating Supply Voltage (max): 1.575V
• Operating Supply Voltage (min): 1.425V
• Supply Current: 355mA
• Pin Count: 96
• Mounting: Surface Mount
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Compliant

PDF: 09005aef826aa906
1Gb_DDR3_SDRAM.pdf – Rev. J 05/10 EN
10. The DES and NOP commands perform similarly.
11. The power-down mode does not perform any REFRESH operations.
12. ZQ CALIBRATION LONG is used for either ZQinit (first ZQCL command during initializa-
2. RESET# is LOW enabled and used only for asynchronous reset. Thus, RESET# must be
3. The state of ODT does not affect the states described in this table.
4. Operations apply to the bank defined by the bank address. For MRS, BA selects one of
5. “V” means “H” or “L” (a defined logic level), and “X” means “Don’t Care.”
6. See Table 68 (page 112) for additional information on CKE transition.
7. Self refresh exit is asynchronous.
8. Burst READs or WRITEs cannot be terminated or interrupted. MRS (fixed) and OTF BL/BC
9. The purpose of the NOP command is to prevent the DRAM from registering any unwan-
held HIGH during any normal operation.
four mode registers.
are defined in MR0.
ted commands. A NOP will not terminate an operation that is executing.
tion) or ZQoper (ZQCL command after initialization).
111
Micron Technology, Inc. reserves the right to change products or specifications without notice.
1Gb: x4, x8, x16 DDR3 SDRAM
Commands – Truth Tables
© 2006 Micron Technology, Inc. All rights reserved.