MCF5282CVM66 Freescale Semiconductor, MCF5282CVM66 Datasheet - Page 393

• Manufacturer Part Number: MCF5282CVM66
• Description: IC MPU 512K 66MHZ 256-MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: MCF528xr

Specifications of MCF5282CVM66

• Core Processor: Coldfire V2
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, Ethernet, I²C, SPI, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 150
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-MAPBGA
• Controller Family/series: ColdFire
• No. Of I/o's: 150
• Ram Memory Size: 64KB
• Cpu Speed: 66.67MHz
• Embedded Interface Type: CAN, I2C, SPI, UART
• No. Of Pwm Channels: 8
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Chapter 21
DMA Timers (DTIM0–DTIM3)
21.1
This chapter describes the configuration and operation of the four direct memory access (DMA) timer
modules (DTIM0, DTIM1, DTIM2, and DTIM3). These 32-bit timers provide input capture and reference
compare capabilities with optional signaling of events using interrupts or DMA triggers. Additionally,
programming examples are included.
21.1.1
Each DMA timer module has a separate register set for configuration and control. The timers can be
configured to operate from the internal bus clock or from an external clocking source using the DTINn
signal. If the internal bus clock is selected, it can be divided by 16 or 1. The selected clock source is routed
to an 8-bit programmable prescaler that clocks the actual DMA timer counter register (DTCNn). Using the
DTMRn, DTXMRn, DTCRn, and DTRRn registers, the DMA timer may be configured to assert an output
signal, generate an interrupt, or request a DMA transfer on a particular event.
Freescale Semiconductor
Introduction
Overview
The designation n appears throughout this section to refer to registers or
signals associated with one of the four identical timer modules: DTIM0,
DTIM1, DTIM2, or DTIM3.
The GPIO module must be configured to enable the peripheral function of
the appropriate pins (refer to
prior to configuring the DMA Timers.
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
Chapter 26, “General Purpose I/O
NOTE
NOTE
Module”)
21-1