MCF5282CVM66 Freescale Semiconductor, MCF5282CVM66 Datasheet - Page 210

• Manufacturer Part Number: MCF5282CVM66
• Description: IC MPU 512K 66MHZ 256-MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: MCF528xr

Specifications of MCF5282CVM66

• Core Processor: Coldfire V2
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, Ethernet, I²C, SPI, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 150
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-MAPBGA
• Controller Family/series: ColdFire
• No. Of I/o's: 150
• Ram Memory Size: 64KB
• Cpu Speed: 66.67MHz
• Embedded Interface Type: CAN, I2C, SPI, UART
• No. Of Pwm Channels: 8
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Edge Port Module (EPORT)
In wait and doze modes, the EPORT module continues to operate as it does in run mode. It may be
configured to exit the low-power modes by generating an interrupt request on either a selected edge or a
low level on an external pin. In stop mode, there are no clocks available to perform the edge-detect
function. Only the level-detect logic is active (if configured) to allow any low level on the external
interrupt pin to generate an interrupt (if enabled) to exit stop mode.
11.3
All pins default to general-purpose input pins at reset. The pin value is synchronized to the rising edge of
CLKOUT when read from the EPORT pin data register (EPPDR). The values used in the edge/level detect
logic are also synchronized to the rising edge of CLKOUT. These pins use Schmitt triggered input buffers
which have built in hysteresis designed to decrease the probability of generating false edge-triggered
interrupts for slow rising and falling input signals.
When a pin is configured as an output, it is driven to a state whose level is determined by the corresponding
bit in the EPORT data register (EPDR). All bits in the EPDR are high at reset.
11-2
Low-power Mode
Interrupt/General-Purpose I/O Pin Descriptions
Doze
Wait
Stop
The input pin synchronizer is bypassed for the level-detect logic since no
clocks are available.
Table 11-1. Edge Port Module Operation in Low-power Modes
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
EPORT Operation
Level-sensing Only
Normal
Normal
NOTE
Any IRQx Interrupt at or above level in LPICR
Any IRQx Interrupt at or above level in LPICR
Any IRQx Interrupt set for level-sensing at or
above level in LPICR
Mode Exit
Freescale Semiconductor