ST7MDT2-EPB2/US STMicroelectronics, ST7MDT2-EPB2/US Datasheet - Page 81

• Manufacturer Part Number: ST7MDT2-EPB2/US
• Description: BOARD PROGRAMMING SGL POS ST7
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of ST7MDT2-EPB2/US

• Contents: Programmer Board
• For Use With/related Products: ST72311, ST72124, ST72314, ST72334
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

SERIAL PERIPHERAL INTERFACE (Cont’d)
14.4.5 Low Power Modes
14.4.6 Interrupts
Note: The SPI interrupt events are connected to
the same interrupt vector (see Interrupts chapter).
They generate an interrupt if the corresponding
Enable Control Bit is set and the interrupt mask in
the CC register is reset (RIM instruction).
WAIT
HALT
SPI End of Transfer Event
Master Mode Fault Event
Mode
No effect on SPI.
SPI interrupt events cause the device to exit from WAIT mode.
SPI registers are frozen.
In HALT mode, the SPI is inactive. SPI operation resumes when the MCU is woken up by an interrupt with
“exit from HALT mode” capability.
Interrupt Event
Description
ST72334J/N, ST72314J/N, ST72124J
MODF
Event
SPIF
Flag
Control
Enable
SPIE
Bit
from
Wait
Exit
Yes
Yes
from
Exit
Halt
81/153
No
No