CY8CKIT-020 Cypress Semiconductor Corp, CY8CKIT-020 Datasheet - Page 70

• Manufacturer Part Number: CY8CKIT-020
• Description: KIT PSOC CY8C28 FAMILY PROCESSOR
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoC®r
• Type: MCUr

Specifications of CY8CKIT-020

• Contents: Board, Software and Documentation
• Silicon Manufacturer: Cypress
• Core Architecture: PSoC
• Features: Programmable System-on-chip Design Methodology And Architecture
• Kit Contents: PSoC CY8C28 Module, Doc, CD
• Silicon Core Number: CY8C28
• Silicon Family Name: PSoC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: CY8C28 Family
• Lead Free Status / Rohs Status: Supplier Unconfirmed
• Other names: 428-3036

MiniProg3 Technical Description
C.1
C.1.1
C.1.2
C.1.3
C.1.4
70
Interfaces
ISSP
In-System Serial Programming (ISSP) is a Cypress legacy interface used to program the PSoC1
family of microcontrollers. MiniProg3 supports programming PSoC1 devices through the 5-pin
connector only.
For more information about the ISSP interface, refer to the PSoC1 Technical Reference Manual.
JTAG
The Joint Test Action Group (JTAG) standard interface is supported by many high end
microcontrollers, including the PSoC 3/ PSoC 5 families. This interface allows a daisy chain bus of
multiple JTAG devices. MiniProg3 supports programming and debugging PSoC 3/ PSoC 5 devices
using JTAG, through the 10-pin connector only.
SWD/SWV
Recent ARM based devices have introduced a new serial debugging standard called Serial Wire
Debug (SWD). The PSoC 3/ PSoC 5 family implements this standard, which offers the same pro-
gramming and debug functions as JTAG, except the boundary scan and daisy chain. SWD uses
fewer pins of the device than the JTAG standard uses. MiniProg3 supports programming and debug-
ging PSoC 3/ PSoC 5 devices, using SWD, through the 5-pin or 10-pin connector.
The Single Wire Viewer (SWV) interface, also introduced by ARM, is used for program and data
monitoring, where the firmware may output data in a method similar to 'printf' debugging on PCs,
using a single pin. MiniProg3 supports monitoring of PSoC 3/ PSoC 5 firmware, using SWV, through
the 10-pin connector and in conjunction with SWD only.
I
A common serial interface standard is the Inter-IC Communication (I
mainly used for communication between microcontrollers and other ICs on the same board, but can
also be used for intersystem communications. MiniProg3 implements an I
controller that allows the tool to exchange data with I
example, this feature may be used to tune CapSense designs.
For more information on the PSoC 3/ PSoC 5 JTAG, SWD, SWV, and I
PSoC 3/ PSoC 5 Technical Reference Manual. For more information on PSoC 1 interfaces, refer to
the PSoC 1 Technical Reference Manual.
2
C™
CY8CKIT-020 PSoC Development Kit Guide, Doc. # 001-56971 Rev. **
2
C enabled devices on the target board. For
2
C) standard by Philips. It is
2
C interfaces, refer to the
2
C multimaster host