STEVAL-ISF001V1 STMicroelectronics, STEVAL-ISF001V1 Datasheet - Page 9

• Manufacturer Part Number: STEVAL-ISF001V1
• Description: BOARD EVAL FOR L6563/STW55NM60N
• Manufacturer: STMicroelectronics
• Type: MOSFET & Power Driverr

Specifications of STEVAL-ISF001V1

• Main Purpose: Power Management, Power Factor Correction
• Embedded: No
• Utilized Ic / Part: L6563
• Primary Attributes: 3 kW, 400 V Out, FOT(Fixed Off Time Control), 240 VAC (185 ~ 265 Vrms)
• Secondary Attributes: Iout Max 7.5 A
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STW55NM60N
• Other names: 497-8850

UM0673
3.2
consequence of maintaining constant T
modulated which gives a variable frequency control.
Using a variable frequency control has advantages in terms of noise input filter size. In fact,
the noise energy is spread over a frequency range with lower energy content for each
frequency.
For further technical information and correct sizing and calculation of the device on the
board, please consult STMicroelectronics’ AN1792 "Design of fixed-off-time-controlled PFC
pre-regulators with the L6562".
The features of the STEVALISF001V1 include:
●
●
●
●
●
●
●
STEVAL-ISF001V1 circuit description
Figure 5
Starting from the input section, a common-mode EMC filter is fitted in order to be compliant
with the EMC regulations concerning industrial and domestic applications. (EN55014 and
EN55022).
The alternative voltage from the mains is then rectified by the input low-frequency bridge
that provides a rectified sinusoidal waveform (with a frequency that is doubled with respect
to the input main waveform) to the next boost stage. The capacitor C7 has been calculated
to have a residual ripple, around the sinusoidal envelope at maximum load and minimum
input voltage, of 6% of the Vin peak value.
The main boost inductor, designed and produced by MAGNETICA (Italy), is a ferrite inductor
core designed to minimize the hysteresis losses.
The technical sheet with a complete order code is given in
The inductor has a secondary-side winding that provides the low-voltage auxiliary supply to
the driver L6563.
At the startup the current and voltage on the main inductor is still zero, so any voltage can
be generated by the secondary auxiliary winding. In this condition, and only during the
startup, the two resistors R7 and R13, 150 kΩ each, with the Zener diode D4 (fitted for
limitation purposes) charge the capacitor C12 and supply the driver that starts the PWM
operation. As soon the PWM signal starts to switch, a voltage is present across the auxiliary
winding, so the low supply voltage across the capacitor C12 is maintained.
The two boost diodes paralleled conduct the peak inductor current at the end of the T
period. At the maximum power and minimum input voltage the peak current can reach 29 A.
Diode D2 and NTC resistor NV1 are used to limit the inrush current, due to the electrolytic
capacitor on the output, during the startup or small decrease of the mains.
PFC FOT power systems based on the L6563
Power stage based on MDmesh™ II Power MOSFET
185 Vrms < Vin rms <265 Vrms
Vout 400 V regulated (±5%)
Iout max 7.5 A
Driver with inductor saturation detection
Optimized EMC input filter.
shows the entire electronic schematic.
Doc ID 15337 Rev 1
OFF
and varying T
ON
Figure
, the overall PWM period is
6.
PFC board connection
ON
9/20