STEVAL-ISF001V1 STMicroelectronics, STEVAL-ISF001V1 Datasheet - Page 6

• Manufacturer Part Number: STEVAL-ISF001V1
• Description: BOARD EVAL FOR L6563/STW55NM60N
• Manufacturer: STMicroelectronics
• Type: MOSFET & Power Driverr

Specifications of STEVAL-ISF001V1

• Main Purpose: Power Management, Power Factor Correction
• Embedded: No
• Utilized Ic / Part: L6563
• Primary Attributes: 3 kW, 400 V Out, FOT(Fixed Off Time Control), 240 VAC (185 ~ 265 Vrms)
• Secondary Attributes: Iout Max 7.5 A
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STW55NM60N
• Other names: 497-8850

Safety and operating instructions
2.2.1
2.2.2
Caution:
2.3
6/20
Electronic connection
National accident prevention rules must be followed when working on the main power
supply, with the power supply, or powering the board in general.
The electrical installation shall be completed in accordance with the appropriate
requirements (e.g., cross-sectional areas of conductors, fusing, PE connections. For further
information, see
3 kW FOT PFC demonstration board setup
It is preferable to use an AC supply isolated and protected against overload and short-circuit
during the evaluation test of the power board 3 kW FOT PFC (in compliance with technical
equipment and accident prevention rules).
A proper load, able to dissipate or in any case absorb and reuse the power delivered by the
system, has to be used. In the case of a resistive and dissipative dummy load, the user must
pay attention to the temperature that the load could reach and provide the necessary
equipment to avoid hot surfaces and fire hazards during the tests (fan, water-cooled load,
etc).
Do not touch the boards and its components after disconnection from the voltage supply, as
several parts and power terminals which contain possibly energized capacitors need to be
allowed to discharge.
Hardware layout
Figure 4.
The mains input connector is present on the right side of the board. Connect a sinusoidal
supply voltage with amplitude in the range of 185 Vrms to 265 Vrms. The power source has
to be able to supply the power required by the system, according to the output load the user
intends to connect on the output port.
Power board 3 kW FOT PFC STEVAL-ISF001V1 (top view)
Section
2.2.2).
Doc ID 15337 Rev 1
UM0673