STEVAL-ISF001V1 STMicroelectronics, STEVAL-ISF001V1 Datasheet - Page 7

• Manufacturer Part Number: STEVAL-ISF001V1
• Description: BOARD EVAL FOR L6563/STW55NM60N
• Manufacturer: STMicroelectronics
• Type: MOSFET & Power Driverr

Specifications of STEVAL-ISF001V1

• Main Purpose: Power Management, Power Factor Correction
• Embedded: No
• Utilized Ic / Part: L6563
• Primary Attributes: 3 kW, 400 V Out, FOT(Fixed Off Time Control), 240 VAC (185 ~ 265 Vrms)
• Secondary Attributes: Iout Max 7.5 A
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STW55NM60N
• Other names: 497-8850

UM0673
Caution:
Note:
Note:
2.4
Note:
Note:
The output connector is present on the left side (close to the output electrolytic capacitors).
Please note that the output voltage is regulated by the system for the target value of 400 V
(consider a tolerance of 5%, due to the net value of the passive components on the board),
which gives a value for a resistive load between 530 Ω ( minimum power delivered) to 53 Ω (
maximum power delivered).
The demonstration board must be handled very carefully, as high-potential (energy) parts
are open and can be touched. The user MUST avoid connecting or removing cables during
operation of the board or touching any part of the system when it is connected to the main
power supply.
After turning the power supply off, if the load is disconnected, the DC-link capacitor may still
hold voltage.
It is preferable to test the kit in ambient temperature not higher than 45 degrees Celsius.
Environmental considerations
The STEVAL-ISF001V1 must only be used in a power laboratory. The high voltage involved
in the system presents a serious shock hazard. If the board is to be used to measure or
capture waveforms or any other interaction between the board and laboratory equipment, an
AC-isolated power supply has to be used.
Any measurement equipment must be isolated from the main power supply before powering
up the PFC. To use an oscilloscope with the kit, it is safer to isolate the AC supply AND the
oscilloscope or use isolated differential probes. This prevents a shock from occurring as a
result of touching any SINGLE point in the circuit but does NOT prevent shocks when
touching TWO or MORE points in the circuit.
An isolated AC power supply can be constructed using an isolation transformer and a
variable transformer.
Isolating the application rather than the oscilloscope is highly recommended in any case.
Warning:
The STEVAL-ISF001V1 has no insulation shield or any other
type of protection.
Doc ID 15337 Rev 1
Safety and operating instructions
7/20