SMC04GBFK6E NUMONYX, SMC04GBFK6E Datasheet - Page 52

• Manufacturer Part Number: SMC04GBFK6E
• Description: MEMORY CARD 4GB COMPACT FLASH
• Manufacturer: NUMONYX

Specifications of SMC04GBFK6E

• Memory Size: 4GB
• Memory Type: CompactFLASH
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CF-ATA registers
9.9.8
9.10
9.10.1
9.10.2
9.10.3
9.10.4
52/90
Bit 0 (ERR)
This bit is set when the previous command has ended in some type of error. The bits in the
error register contain additional information describing the error. In case of read or write
access commands that end with an error, the address of the first sector with an error is in
the command block registers. This bit is cleared by the next command.
Table 45.
Device control register
The device control register is located at address 3F6h [376h], offset Eh.
This write-only register is used to control the CompactFlash memory card interrupt request
and to issue an ATA soft reset to the card. This register can be written even if the device is
BUSY. The bits are defined as follows.
Bit 7 to 3
Don’t care. The host should reset this bit to ‘0’.
Bit 2 (SW Rst)
This bit is set to ‘1’ to force the CompactFlash storage card to perform an AT disk controller
soft reset operation. This clears status register and writes diagnostic code in error register
after a write or read sector error. The card remains in reset until this bit is reset to ‘0.’
Bit 1 (–IEn)
When the interrupt enable bit is set to ‘0’, –IREQ interrupts are enabled. When the bit is set
to ‘1’, interrupts from the card are disabled. This bit also controls the int bit in the card
configuration and status register. It is set to ‘0’ at power-on.
Bit 0
This bit is set to ‘0’.
Table 46.
BUSY
X(0)
D7
D7
Status & alternate status register
Device control register
RDY
X(0)
D6
D6
DWF
X(0)
D5
D5
DSC
X(0)
D4
D4
DRQ
X(0)
D3
D3
SW Rst
CORR
D2
D2
–IEn
D1
D1
0
SMCxxxBF
ERR
D0
D0
0