ISL6755AAZA-T Intersil, ISL6755AAZA-T Datasheet - Page 16

• Manufacturer Part Number: ISL6755AAZA-T
• Description: IC CTRLR PWM FULL-BRDG 20-QSOP
• Manufacturer: Intersil

Specifications of ISL6755AAZA-T

• Pwm Type: Voltage/Current Mode
• Number Of Outputs: 4
• Frequency - Max: 2MHz
• Duty Cycle: 100%
• Voltage - Supply: 9 V ~ 16 V
• Buck: No
• Boost: No
• Flyback: No
• Inverting: No
• Doubler: No
• Divider: No
• Cuk: No
• Isolated: No
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 20-QSOP
• Frequency-max: 2MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The first power transfer period commences when switch LR
closes and the cycle repeats. The ZVS transition requires
that the leakage inductance has sufficient energy stored to
fully charge the parasitic capacitances. Since the energy
stored is proportional to the square of the current (1/2 L
the ZVS resonant transition is load dependent. If the leakage
inductance is not able to store sufficient energy for ZVS, a
discrete inductor may be added in series with the
transformer primary.
VIN+
VIN-
FIGURE 19. UPPER SWITCH TOGGLE AND RESONANT
UL
LL
I
P
TRANSITION
UR
LR
L
L
16
D1
D2
I
S
L
I
VOUT+
P
RTN
2
),
ISL6755
Fault Conditions
A fault condition occurs if VREF or VDD fall below their
undervoltage lockout (UVLO) thresholds or if the thermal
protection is triggered. When a fault is detected, the soft-
start capacitor is quickly discharged, and the outputs are
disabled low. When the fault condition clears and the soft-
start voltage is below the reset threshold, a soft-start cycle
begins.
An overcurrent condition is not considered a fault and does
not result in a shutdown.
Thermal Protection
Internal die over-temperature protection is provided. An
integrated temperature sensor protects the device should
the junction temperature exceed +140°C. There is
approximately +15°C of hysteresis.
Ground Plane Requirements
Careful layout is essential for satisfactory operation of the
device. A good ground plane must be employed. V
V
frequency capacitance.
References
[1] Ridley, R., “A New Continuous-Time Model for Current
REF
Mode Control”, IEEE Transactions on Power
Electronics, Vol. 6, No. 2, April 1991.
should be bypassed directly to GND with good high
September 29, 2008
DD
FN6442.1
and