S9S08DZ60F2MLH Freescale Semiconductor, S9S08DZ60F2MLH Datasheet - Page 64

• Manufacturer Part Number: S9S08DZ60F2MLH
• Description: 8-bit Microcontrollers - MCU M74K MASK ONLY-AUTO
• Manufacturer: Freescale Semiconductor

Specifications of S9S08DZ60F2MLH

• Rohs: yes
• Core: HCS08
• Processor Series: MC9S08DZ60
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 40 MHz
• Program Memory Size: 60 KB
• Data Ram Size: 4 K
• On-chip Adc: Yes
• Operating Supply Voltage: 2.7 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT

1
1
Chapter 4 Memory
4.5.11.3
4.5.11.4
The FPROT register defines which Flash and EEPROM sectors are protected against program and erase
operations.
During the reset sequence, the FPROT register is loaded from the nonvolatile location NVPROT. To
change the protection that will be loaded during the reset sequence, the sector containing NVPROT must
be unprotected and erased, then NVPROT can be reprogrammed.
FPROT bits are readable at any time and writable as long as the size of the protected region is being
increased. Any write to FPROT that attempts to decrease the size of the protected memory will be ignored.
Trying to alter data in any protected area will result in a protection violation error and the FPVIOL flag
will be set in the FSTAT register. Mass erase is not possible if any one of the sectors is protected.
64
User must write a 1 to this bit. Failing to do so may result in unexpected behavior.
Background commands can be used to change the contents of these bits in FPROT.
EPGSEL
KEYACC
Reset
Reset
Field
6
5
W
W
R
R
EEPROM Page Select — This bit selects which EEPROM page is accessed in the memory map.
0 Page 0 is in foreground of memory map. Page 1 is in background and can not be accessed.
1 Page 1 is in foreground of memory map. Page 0 is in background and can not be accessed.
Enable Writing of Access Key — This bit enables writing of the backdoor comparison key. For more detailed
information about the backdoor key mechanism, refer to
0 Writes to 0xFFB0–0xFFB7 are interpreted as the start of a Flash programming or erase command.
1 Writes to NVBACKKEY (0xFFB0–0xFFB7) are interpreted as comparison key writes.
Flash and EEPROM Configuration Register (FCNFG)
0
0
Flash and EEPROM Protection Register (FPROT and NVPROT)
7
7
EPS
= Unimplemented or Reserved
1
EPGSEL
Figure 4-8. Flash and EEPROM Protection Register (FPROT)
0
6
6
This register is loaded from nonvolatile location NVPROT during reset.
Figure 4-7. Flash Configuration Register (FCNFG)
Table 4-11. FCNFG Register Field Descriptions
KEYACC
MC9S08DZ60 Series Data Sheet, Rev. 4
0
5
5
Reserved
1
4
4
Description
1
Section 4.5.9,
3
0
0
3
FPS
1
“Security.”
0
0
2
2
Freescale Semiconductor
0
0
1
1
1
1
0
0