MC9S08SG32E1JTGR FREESCALE [Freescale Semiconductor, Inc], MC9S08SG32E1JTGR Datasheet - Page 71

• Manufacturer Part Number: MC9S08SG32E1JTGR
• Description: HCS08 Microcontrollers
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

1
2
5.7.6
This high page register contains status and control bits to support the low-voltage detect function, and to
enable the bandgap voltage reference for use by the ADC and ACMP modules. This register should be
written during the user’s reset initialization program to set the desired controls even if the desired settings
are the same as the reset settings.
Freescale Semiconductor
LVWF will be set in the case when V
This bit can be written only one time after reset. Additional writes are ignored.
Reset:
LVWACK
LVDRE
LVDSE
LVWIE
BGBE
LVWF
LVDE
Field
7
6
5
4
3
2
0
W
R
LVWF
System Power Management Status and Control 1 Register
(SPMSC1)
Low-Voltage Warning Flag — The LVWF bit indicates the low voltage warning status.
0 Low voltage warning is not present.
1 Low voltage warning is present or was present.
Low-Voltage Warning Acknowledge — The LVWF bit indicates the low voltage warning status.Writing a 1 to
LVWACK clears LVWF to a 0 if a low voltage warning is not present.
Low-Voltage Warning Interrupt Enable — This bit enables hardware interrupt requests for LVWF.
0 Hardware interrupt disabled (use polling).
1 Request a hardware interrupt when LVWF = 1.
Low-Voltage Detect Reset Enable — This write-once bit enables LVD events to generate a hardware reset
(provided LVDE = 1).
0 LVD events do not generate hardware resets.
1 Force an MCU reset when an enabled low-voltage detect event occurs.
Low-Voltage Detect Stop Enable — Provided LVDE = 1, this write-once bit determines whether the low-voltage
detect function operates when the MCU is in stop mode.
0 Low-voltage detect disabled during stop mode.
1 Low-voltage detect enabled during stop mode.
Low-Voltage Detect Enable — This write-once bit enables low-voltage detect logic and qualifies the operation
of other bits in this register.
0 LVD logic disabled.
1 LVD logic enabled.
Bandgap Buffer Enable — This bit enables an internal buffer for the bandgap voltage reference for use by the
ADC and ACMP modules.
0 Bandgap buffer disabled.
1 Bandgap buffer enabled.
Figure 5-8. System Power Management Status and Control 1 Register (SPMSC1)
0
7
1
= Unimplemented or Reserved
LVWACK
0
0
6
Table 5-9. SPMSC1 Register Field Descriptions
Supply
LVWIE
transitions below the trip point or after reset and V
0
5
MC9S08SG32 Data Sheet, Rev. 7
LVDRE
1
4
2
Description
Chapter 5 Resets, Interrupts, and General System Control
LVDSE
3
1
2
LVDE
1
2
2
Supply
is already below V
0
0
1
BGBE
LVW
0
0
71