MC9S08SG32E1JTGR FREESCALE [Freescale Semiconductor, Inc], MC9S08SG32E1JTGR Datasheet - Page 185

• Manufacturer Part Number: MC9S08SG32E1JTGR
• Description: HCS08 Microcontrollers
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

12.1.2
Timer system features include:
12.1.3
This section defines the MTIM’s operation in stop, wait and background debug modes.
12.1.3.1
The MTIM continues to run in wait mode if enabled before executing the WAIT instruction. Therefore, the
MTIM can be used to bring the MCU out of wait mode if the timer overflow interrupt is enabled. For lowest
possible current consumption, the MTIM should be stopped by software if not needed as an interrupt
source during wait mode.
12.1.3.2
The MTIM is disabled in all stop modes, regardless of the settings before executing the STOP instruction.
Therefore, the MTIM cannot be used as a wake up source from stop modes.
Waking from stop2 mode, the MTIM will be put into its reset state. If stop3 is exited with a reset, the
MTIM will be put into its reset state. If stop3 is exited with an interrupt, the MTIM continues from the
state it was in when stop3 was entered. If the counter was active upon entering stop3, the count will resume
from the current value.
12.1.3.3
The MTIM suspends all counting until the microcontroller returns to normal user operating mode.
Counting resumes from the suspended value as long as an MTIM reset did not occur (TRST written to a 1
or MTIMMOD written).
Freescale Semiconductor
•
•
•
8-bit up-counter
— Free-running or 8-bit modulo limit
— Software controllable interrupt on overflow
— Counter reset bit (TRST)
— Counter stop bit (TSTP)
Four software selectable clock sources for input to prescaler:
— System bus clock — rising edge
— Fixed frequency clock (XCLK) — rising edge
— External clock source on the TCLK pin — rising edge
— External clock source on the TCLK pin — falling edge
Nine selectable clock prescale values:
— Clock source divide by 1, 2, 4, 8, 16, 32, 64, 128, or 256
Features
Modes of Operation
MTIM in Wait Mode
MTIM in Stop Modes
MTIM in Active Background Mode
MC9S08SG32 Data Sheet, Rev. 7
Chapter 12 Modulo Timer (S08MTIMV1)
185