kac-9638 ETC-unknow, kac-9638 Datasheet - Page 42

• Manufacturer Part Number: kac-9638
• Description: Kodak Kac-9638 Cmos Image Sensor
• Manufacturer: ETC-unknow

IMAGE SENSOR SOLUTIONS
Revision Changes
KAC-9638
www.kodak.com/go/imagers 585-722-4385
Revison
Number
1.94
Description
Page 3 - moved figure 1 text so it was outside of diagram
Page 3 - changed ordering information as follows: Changed package field to part number, added Kodak part
numbers, added lens kit information.
Page 5 - Added text stating SDA and SCLK were open drain I/O’s
Page 6 - Changed Pin 45 from Pwn to Pwd to match rest of datasheet
Page 9 - Under Blemish Specification changed National Semiconductor to Eastman Kodak
Page 13 and 14 - changed all references to 2:1 subsampling to sub-sampling
Page 14 - Section 5.4 changed all references to 2:1 sub-sampling to 4:2 sub-sampling
Page 14 - updated figure references to refer to proper figure
Page 16 - Section 6.3 in section defining Hclk changed Mclk can be divided by 2,4, or 6 to say Mclk can be
divided by 1 or 2.
Page 17 - Section 6.4 corrected all references to WEndCol as end column and WStartCol as start column
Page 17 - Section 6.4 corrected all references to WEndRow as end row and WStartRow as start row.
Page 17 - Section 6.4 changed Fdelays maximum programmable value from 32766 to 32767
Page 15 - under figure 14 after the following words “The following factors effect exposure and signal level”
changed integration time to programmed partial frame integration.
Page 18 - Section 7.3 changed max external trigger pulse from 32768 to 32767
Page 18 - Section 7.3 changed array reset from 0-8 frames to 1-8 frames.
Page 19 - Section 9.2 changed pwdn pin to pwd pin.
Page 19 - Section 9.2 removed bandgap references and replaced with internal reference ladder.
Page 20 - Section 10.0 added that Mclk must be running and 4x faster than Sclk for I2C to work.
Page 21 - Section 11.2 added section title to Synchronisation Signals ...
Page 24 - added section heading for Slave Mode
Page 24 - added arrow to Pclk in Figure 51
Page 25 and 27 - Register 0x09h OPCTRL - changed reset value from 0x02h to 0x06h
Page 25 and 27 - Register 0x01h REV - changed reset value from Latest Silicon to 0x09h
Page 27 - Register 0x05h VCLKGEN - changed bit 2 to reserved. Can only divide Mclk by a maximum of 2
Page 29 - Register 0x1Bh - changed bits 1:0 of both WStartRow and WEndRow to be reservered.
Page 29 - Register 0x1Eh - changed bits 1:0 of both WStartCol and WEndCol to be reservered.
Page 40 - updated descriptions so they matched drawing.
All Pages - removed part number from side of page and added part number to bottom of page.
Added Revision history to datasheet.
42
Email:[e-mail]