emc2104 Standard Microsystems Corp., emc2104 Datasheet - Page 14

• Manufacturer Part Number: emc2104
• Description: Emc2104 Dual Rpm-based Pwm Fan Controller With Hardware Thermal Shutdown
• Manufacturer: Standard Microsystems Corp.

Chapter 3 Electrical Specifications
Revision 1.74 (05-08-08)
3.1
VDD = 3V to 3.6V, VDD_5V = 4.5V to 5.5V, T
Supply Voltage
Supply Current
(active)
Supply Current
CHARACTERISTIC
Voltage on 5V tolerant pins
Voltage on VDD pin
Voltage on 2V tolerant pins
Voltage on any other pin to GND
Package Power Dissipation See
Junction to Ambient (θ
Operating Ambient Temperature Range
Storage Temperature Range
ESD Rating, All Pins, HBM
Note: Stresses above those listed could cause permanent damage to the device. This is a stress
Note 3.1
Note 3.2
Electrical Specifications
rating only and functional operation of the device at any other condition above those indicated
in the operation sections of this specification is not implied. When powering this device from
laboratory or system power supplies, it is important that the Absolute Maximum Ratings not be
exceeded or device failure can result. Some power supplies exhibit voltage spikes on their
outputs when the AC power is switched on or off. In addition, voltage transients on the AC
power line may appear on the DC output. If this possibility exists, it is suggested that a clamp
circuit be used.
JA
SYMBOL
) See
All voltages are relative to ground.
The Package Power Dissipation specification assumes a recommended thermal via design
consisting of four 12mil vias connected to the ground plane with a 2x2mm thermal landing.
V
I
I
DD
DD
DD
Note 3.2
Note 3.1
Table 3.1 Absolute Maximum Ratings
Table 3.2 Electrical Specifications
MIN
3
A
= -40°C to 85°C, all Typical values at T
DATASHEET
Dual RPM-Based PWM Fan Controller with Hardware Thermal Shutdown
TYP
DC Power
500
3.3
2
noted.
14
MAX
750
3.6
3
-0.3 to 6.5
-0.3 to 4
-0.3 to 2.5
-0.3 to VDD + 0.3
1 up to T
40
-40 to 85°C
-55 to 150
2000
UNIT
mA
uA
V
A
= 85°C
4 Conversions / second -
Dynamic Averaging Enabled
Fan Driver enabled at max PWM
frequency
1 Conversions / second-
Dynamic Averaging disabled,
Fan Driver disabled.
A
= 27°C unless otherwise
CONDITIONS
SMSC EMC2104
V
V
V
V
W
°C/W
°C
°C
V
Datasheet