lan83c175 Standard Microsystems Corp., lan83c175 Datasheet - Page 69

• Manufacturer Part Number: lan83c175
• Description: Ethernet Cardbus Integrated Controller With Modem Support Corporation
• Manufacturer: Standard Microsystems Corp.

OPERATIONAL DESCRIPTION
Maximum Guaranteed Ratings
Operating Temperature Range......................................................................................... 0 C To +70 C
Storage Temperature Range....................................................................................... -55 C To +150 C
Lead Temperature Range (soldering, 10 Seconds).................................................................... +325 C
Positive Voltage on any pin with respect to Ground .............................................................. V
Negative Voltage on any pin with respect to Ground..................................................................... -0.3V
Maximum V
The above is a stress rating only. Stresses greater than the ones listed above could damage the
device permanently. Device operation outside of the above stated conditions is not recommended.
Note: When powering this device from a laboratory or system power supply, it is important that the
Absolute Maximum Ratings are not exceeded. Some power supplies exhibit voltage spikes on their
outputs when the AC power is switched on or off. Also, voltage transients on the AC power line may
appear on the DC outputs. If such possibilities exist, a clamping circuit should be used.
DC Electrical Characteristics
(T = 0 C — +70 C; V
Current - Startup
Current - 10 or 100Mb/s
Busy (Active TX &/or RX)
Current - 10 or 100Mb/s
Idle
Current - S/W Power
Down
Current - Bus Clock Stop
&10 or 100Mb/s Idle
Current - Bus Clock Stop
& Cable Removed
Current - Bus Clock Stop
& S/W Power Down
*
active time). As the chip drops back to the idle state immediately at the end of a TX or RX, the actual
time-averaged current consumption will be between the Busy and Idle numbers.
5mA per LED lit. LEDs’ activity light pulses are stretched into milliseconds (a lot longer than the chip
PARAMETER
DD ...................................................................................................................................................................................................................................
DD
= +3.3V +/-10%)
SYMBOL
I
I
I
I
DPWDN-nc
DSBY-nc
DSBY-nc
DPWDN
I
I
DSBY
I
DDP
DD
MIN
69
TYP
40
75
65
40
50
50
25
MAX
UNITS
mA
mA
mA
mA
mA
mA
mA
LED
LED = 10 mA
LED = 5 mA
LED = 0 mA
LED = 5 mA
LED = 0 mA
LED = 0 mA
*
COMMENTS
= 0 mA
DD
+TBDV
+ 0.3V