mpc82x52a Megawin Technology, mpc82x52a Datasheet - Page 57

• Manufacturer Part Number: mpc82x52a
• Description: 8-bit Micro-controller
• Manufacturer: Megawin Technology

Power Management
MEGAWIN
IDLE Mode
An instruction setting PCON.0 causes the device go into the idle mode, and the internal clock
is gated off to the CPU but not to the interrupt, timer, PCA, SPI, ADC, WDT and serial port
functions.
There are two ways to terminate the idle. Activation of any enabled interrupt will cause
PCON.0 to be cleared by hardware in order to terminating the idle mode. The interrupt will be
serviced, and following RETI instruction: the next instruction to be executed will be performed
right after the instruction that puts the device into idle. Another way to wake-up from idle is to
pull pin RST high to generate internal hardware reset.
Save Power Consumption under IDLE Mode
A clock divider(CLKDIV) associated with idle mode is used to slow down the system clock
source in order to save power in advance. Slower the clock oscillates, and less power is
consumed. Software could program this clock divider register prior to enter the idle mode.
When the chip enters the idle mode, the clock is switched to the divider. When the chip exits
the idle mode, clocking will return to the original clock behavior.
SFR: PCON2 (Power Control 2)
{CKS2, CKS1, CKS0 }: Clock selector under idle mode
Bit-7
-
Bit-6
{0, 0,0} : = (default)
{0, 0, 1} : =
{0, 1, 0} : =
{0, 1, 1} : =
{1, 0,0} : =
{1, 0, 1} : =
{1, 1, 0} : =
{1, 1, 1} : =
-
In idle mode, clock is not divided (default state)
In idle mode, clock is divided by 2
In idle mode, clock is divided by 4
In idle mode, clock is divided by 8
In idle mode, clock is divided by 16
In idle mode, clock is divided by 32
In idle mode, clock is divided by 64
In idle mode, clock is divided by 128
Bit-5
-
MPC82x52A Data Sheet
Bit-4
-
Bit-3
-
CKS2
Bit-2
CKS1
Bit-1
CKS0
Bit-0
57