s908ab32ag0cfue Freescale Semiconductor, Inc, s908ab32ag0cfue Datasheet - Page 63

• Manufacturer Part Number: s908ab32ag0cfue
• Description: M68hc08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

4.7 FLASH Program/Read Operation
MC68HC908AB32
Freescale Semiconductor
NOTE:
—
Rev. 1.1
Programming of the FLASH memory is done on a row basis. A row
consists of 64 consecutive bytes starting from addresses $XX00,
$XX40, $0080 and $XXC0. Use this step-by-step procedure to program
a row of FLASH memory
In order to avoid program disturbs, the row must be erased before any
byte on that row is programmed.
* The time between each FLASH address change, or the time between the last FLASH address
programmed to clearing PGM bit, must not exceed the maximum programming time, t
This program sequence is repeated throughout the memory until all data
is programmed.
10. Clear the PGM bit.*
11. Wait for a time, t
12. Clear the HVEN bit.
13. After time, t
1. Set the PGM bit. This configures the memory for program
2. Read from the FLASH block protect register.
3. Write any data to any FLASH address within the row address
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Write data to the FLASH address to be programmed.*
8. Wait for a time, t
9. Repeat step 7 and 8 until all the bytes within the row are
operation and enables the latching of address and data for
programming.
range desired.
programmed.
mode again.
FLASH Memory
rcv
(min. 1µs), the memory can be accessed in read
nvs
pgs
PROG
nvh
(Figure 4-2
(min. 10µs).
(min. 5µs).
(min. 5µs).
(min. 30µs).
is a flowchart representation):
FLASH Memory
Technical Data
PROG
max.
63