AT32UC3A464 Atmel Corporation, AT32UC3A464 Datasheet - Page 373

• Manufacturer Part Number: AT32UC3A464
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A464

• Flash (kbytes): 64 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

10. Revision History
10.1
10.2
10.3
10.4
32000D–04/2011
Rev. 32000A-02/2006
Rev. 32000B-11/2007
Rev. 32000C-08/2009
Rev. 32000D-04/2011
1.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
Initial version.
Improved description of RETE in Instruction Set Chapter.
Corrected description of STC.D in Instruction Set Chapter.
Added micro-TLB miss performance counting.
Added clear-on-compare functionality to COUNT system register
Updated MPU description to match implementation
Added new architecture revision 2 instructions
Corrected typos in the MOVH instruction description.
Corrected Reset address typo in chapter 7.3.1.1
Corrected typos in RETE, DIVS and DIVU detailed instruction set descriptions.
Described new architecture revision 3 secure execution state.
Automatic clear of COUNT on COMPARE match can now be overridden, usually
by writing a bit in the implementation’s CPUCR register.
FlashVault™ description added
Instruction syntax: Each Ri<part> has been replaced by Ri:<part> in the instruc-
tion set summary and descriptions
Added description of bit 7 in Op8 in sleep instruction
Parantheses added to shift instruction descriptions to clarify the order of the
operations
Added cond4 to ld.sb, ld.ub, ld.sh, ld.uh, ld.w, st.b, st.h, st.w instruction descrip-
tion syntax
SE replaced by ZE in st.w{cond4} in the Instruction Set Summary table
AVR32
373