AT32UC3A4128S Atmel Corporation, AT32UC3A4128S Datasheet - Page 640

• Manufacturer Part Number: AT32UC3A4128S
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A4128S

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: AES
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

26.7.2.13
32072G–11/2011
Management of OUT endpoints
•Overview
Figure 26-18. Abort Algorithm
OUT packets are sent by the host. All the data can be read which acknowledges or not the bank
when it is empty.
The endpoint must be configured first.
The RXOUTI bit is set at the same time as FIFOCON when the current bank is full. This triggers
an EPnINT interrupt if the Received OUT Data Interrupt Enable (RXOUTE) bit in UECONn is
one.
RXOUTI shall be cleared by software (by writing a one to the Received OUT Data Interrupt Clear
(RXOUTIC) bit) to acknowledge the interrupt, what has no effect on the endpoint FIFO.
The user then reads from the FIFO (see
DATA)” on page
composed of multiple banks, this also switches to the next bank. The RXOUTI and FIFOCON
bits are updated in accordance with the status of the next bank.
RXOUTI shall always be cleared before clearing FIFOCON.
The RWALL bit is set when the current bank is not empty, i.e. the software can read further data
from the FIFO.
TXINEC = 1
EPRSTn = 1
Abort Done
NBUSYBK
Endpoint
Abort
740) and clears the FIFOCON bit to free the bank. If the OUT endpoint is
== 0?
Yes
No
Yes
KILLBKS = 1
KILLBK
No
”USB Pipe/Endpoint n FIFO Data Register (USBFIFOn-
== 1?
Disable the TXINI interrupt.
Abort is based on the fact
that no bank is busy, i.e.,
that nothing has to be sent
Wait for the end of the
procedure
Kill the last written bank.
640