RC28F320J3F75A Micron Technology Inc, RC28F320J3F75A Datasheet - Page 54

• Manufacturer Part Number: RC28F320J3F75A
• Manufacturer: Micron Technology Inc

Specifications of RC28F320J3F75A

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Figure 22: Set Block Lock-Bit Flowchart
Datasheet
54
FULL STATUS CHECK PROCEDURE
Set Lock-Bit Complete
Read Status Register
Read Status Register
Data (See Above)
Check if Desired
Block Address
Block Address
Set Lock-Bit
Write 60H,
Write 01H,
Full Status
Successful
SR.4,5 =
SR.7 =
SR.3 =
SR.4 =
Start
0
0
0
1
0
1
1
1
Command Sequence
Voltage Range Error
Set Lock-Bit Error
Error
Numonyx
®
Embedded Flash Memory (J3 65 nm) Single Bit per Cell (SBC)
Repeat for subsequent lock-bit operations.
Full status check can be done after each lock-bit set operation or after
a sequence of lock-bit set operations.
Write FFH after the last lock-bit set operation to place device in read
array mode.
SR.5, SR.4 and SR.3 are only cleared by the Clear Status Register
command, in cases where multiple lock-bits are set before full status is
checked.
If an error is detected, clear the status register before attempting retry
or other error recovery.
Operation
Operation
Standby
Standby
Standby
Standby
Write
Write
Read
Bus
Bus
Set Block Lock-Bit
Set Block Lock-Bit
Command
Command
Confirm
Setup
Check SR.3
1 = Programming Voltage Error
Check SR.4, 5
Both 1 = Command Sequence
Check SR.4
1 = Set Lock-Bit Error
Error
Detect
Data = 60H
Addr =Block Address
Data = 01H
Addr = Block Address
Status Register Data
Check SR.7
1 = WSM Ready
0 = WSM Busy
Comments
Comments
208032-03
Jan 2011