NOIS1SM0250A-HHC ON Semiconductor, NOIS1SM0250A-HHC Datasheet - Page 17

• Manufacturer Part Number: NOIS1SM0250A-HHC
• Manufacturer: ON Semiconductor

Specifications of NOIS1SM0250A-HHC

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Table 11. Digital Output Signals
Table 12. Analog Input Signals
Table 13. Analog Output Signals
Table 14. Test Structures
Pin
Pin
Pin
Pin
58
59
60
61
62
63
64
39
40
41
42
44
45
46
47
70
48
72
73
74
43
81
82
83
84
TESTPIXEL_RESET
TESTPIXEL_OUT
PBIASENCLOAD
NBIAS_AMP
VHIGH_ADC
TESTDIODE
NBIASANA2
VLOW_ADC
BLACKREF
PBIASDIG2
PBIASDIG1
NBIASARR
NBIASANA
Pin Name
Pin Name
Pin Name
Pin Name
TESTPIX
IN_ADC
ARRAY
PBIAS
G_AB
OUT
D3
D4
D5
D6
D7
D8
D9
ADC output bit
ADC output bit
ADC output bit
ADC output bit
ADC output bit
ADC output bit
ADC output bit (MSB)
Connect with 470 k to V
Connect with 39 k to ground and decouple to V
rate. (Lower resistor values yield higher maximal pixel rates at the cost of extra power
dissipation).
Output amplifier speed/power control.
Connect with 51 k to V
resistor values yield higher maximal pixel rates at the cost of extra power dissipation).
Control voltage for output signal offset level.
Buffered on-chip, the reference level can be generated by a 100 k resistive divider.
Connect to ± 2 V DC for use with on-chip ADC.
Input, connect to sensor output.
Input range is between 2 and 4 V (VLOW_ADC and VHIGH_ADC).
Connect with 100 k to V
Connect with 100 k to V
Low reference and high reference voltages of ADC should be about 2 V and 4 V.
The required voltage settings on VLOW_ADC and VHIGH_ADC can be approximated by
tying VLOW_ADC with 1.2 k to GND and VHIGH_ADC with 560  to V
Antiblooming drain control voltage:
Default: connect to ground. The antiblooming is operational but not maximal.
Apply 1 V DC for improved antiblooming.
Connect with 100 K to GND and decouple to V
Connect with 100 K to GND and decouple to V
Connect with 47 K to GND and decouple to V
Analog output signal are connected to the analog input of the ADC.
Plain photo diode, size: 14 × 25 pixels.
Must be left open for normal operation.
Array of test pixels, connected in parallel (14 × 25 pixels).
Must be left open for normal operation.
Reset input of single test pixel.
Must be tied to GND for normal operation.
Output of single test pixel.
Must be left open for normal operation.
Rev. 7 | www.onsemi.com | Page 17 of 22
DD
DD
DD
DD
and decouple to ground with a 100 nF capacitor.
and decouple with 100 nF to GND for 8 MHz output rate (Lower
and decouple to GND.
and decouple to GND.
Pin Description
Pin Description
Pin Description
Pin Description
DD
DD
DD
DD
.
.
.
with a 100 nF capacitor for 8 MHz pixel
NOIS1SM0250A
DD
.