LAN8710A-EZK SMSC, LAN8710A-EZK Datasheet - Page 14

• Manufacturer Part Number: LAN8710A-EZK
• Description: TXRX ETHERNET 10/100 MII/RMII
• Manufacturer: SMSC
• Type: Transceiverr

Specifications of LAN8710A-EZK

• Number Of Drivers/receivers: 4/4
• Protocol: MII, RMII
• Voltage - Supply: 1.6 V ~ 3.6 V
• Mounting Type: Surface Mount
• Package / Case: 32-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 638-1079; LAN8710A-EZK

Chapter 3 Pin Description
Revision 1.0 (04-15-09)
3.1
BUFFER TYPE
SIGNAL
NAME
TXD0
TXD1
Note 3.1
Note 3.1
Note 3.1
Note 3.1
OCLK
IOPU
IOPD
IOD8
ICLK
IPU
IPD
AIO
O8
AI
I8
P
This chapter describes the signals on each pin. When a lower case “n” is used at the beginning of the
signal name, it indicates that the signal is active low. For example, nRST indicates that the reset signal
is active low. The buffer type for each signal is indicated in the TYPE column, and a description of the
buffer types is provided in
Note 3.1
Note: The digital signals are not 5V tolerant.They are variable voltage from +1.6V to +3.6V, as shown
MAC Interface Signals
32-QFN
PIN #
22
23
in
Input.
Output with 8mA sink and 8mA source.
Input/Open-drain output with 8mA sink.
Input with 67k (typical) internal pull-up.
Input with 67k (typical) internal pull-down.
Input/Output with 67k (typical) internal pull-up. Output has 8mA sink and 8mA source.
Input/Output with 67k (typical) internal pull-down. Output has 8mA sink and 8mA source.
Analog input
Analog bi-directional
Crystal oscillator input pin
Crystal oscillator output pin
Power pin
Table
Unless otherwise noted in the pin description, internal pull-up and pull-down resistors are
always enabled. The internal pull-up and pull-down resistors prevent unconnected inputs
from floating, and must not be relied upon to drive signals external to
When connected to a load that must be pulled high or low, an external resistor must be
added.
TYPE
7.1.
I8
I8
Transmit Data 0: The MAC transmits data to the transceiver using this
signal in all modes.
Transmit Data 1: The MAC transmits data to the transceiver using this
signal in all modes
Table 3.2 MII/RMII Signals 32-QFN
Table
Table 3.1 Buffer Types
MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR
3.1.
DATASHEET
14
DESCRIPTION
DESCRIPTION
SMSC LAN8710/LAN8710i
®
Technology in a Small Footprint
LAN8710/LAN8710i
Datasheet
.