EP2C5F256C8 Altera, EP2C5F256C8 Datasheet - Page 158

• Manufacturer Part Number: EP2C5F256C8
• Description: IC CYCLONE II FPGA 5K 256-FBGA
• Manufacturer: Altera
• Series: Cyclone® IIr

Specifications of EP2C5F256C8

• Number Of Logic Elements/cells: 4608
• Number Of Labs/clbs: 288
• Total Ram Bits: 119808
• Number Of I /o: 158
• Voltage - Supply: 1.15 V ~ 1.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 256-FBGA
• Family Name: Cyclone® II
• Number Of Logic Blocks/elements: 4608
• # I/os (max): 158
• Frequency (max): 402.58MHz
• Process Technology: 90nm
• Operating Supply Voltage (typ): 1.2V
• Logic Cells: 4608
• Ram Bits: 119808
• Operating Supply Voltage (min): 1.15V
• Operating Supply Voltage (max): 1.25V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 256
• Package Type: FBGA
• No. Of Macrocells: 4608
• Family Type: Cyclone II
• No. Of I/o's: 158
• Clock Management: PLL
• I/o Supply Voltage: 3.6V
• Operating Frequency Max: 320MHz
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Not Compliant
• Other names: 544-1446

Duty Cycle Distortion
Figure 5–9. DCD Measurement Technique for Non-DDIO (Single-Data Rate) Outputs
5–68
Cyclone II Device Handbook, Volume 1
clk
DCD Measurement Techniques
DCD is measured at an FPGA output pin driven by registers inside the
corresponding I/O element (IOE) block. When the output is a single data
rate signal (non-DDIO), only one edge of the register input clock (positive
or negative) triggers output transitions
present on the input clock signal, or caused by the clock input buffer, or
different input I/O standard, does not transfer to the output signal.
However, when the output is a double data rate input/output (DDIO)
signal, both edges of the input clock signal (positive and negative) trigger
output transitions
clock and the input clock buffer affect the output DCD.
IOE
(T/2 – D1) / T (the low percentage boundary)
(T/2 + D2) / T (the high percentage boundary)
(Figure
DFF
D
5–10). Therefore, any distortion on the input
Q
(Figure
5–9). Therefore, any DCD
Altera Corporation
output
February 2008