DSP56301PW80 Freescale Semiconductor, DSP56301PW80 Datasheet - Page 18

• Manufacturer Part Number: DSP56301PW80
• Description: IC DSP 24BIT 80MHZ 208-LQFP
• Manufacturer: Freescale Semiconductor
• Series: DSP563xxr
• Type: Fixed Pointr

Specifications of DSP56301PW80

• Interface: Host Interface, SSI, SCI
• Clock Rate: 80MHz
• Non-volatile Memory: ROM (9 kB)
• On-chip Ram: 24kB
• Voltage - I/o: 3.30V
• Voltage - Core: 3.30V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Signals/Connections
1-14
HSERR
HIRQ
HSTOP
HWR/HRW
HIDSEL
HRD/HDS
HFRAME
Signal Name
Output, open
drain
Output, open
drain
Input/
Output
Input
Input
Input
Input/
Output
Type
Tri-stated
Tri-stated
Input
Tri-stated
State During
Table 1-11.
Reset
DSP56301 Technical Data, Rev. 10
Host System Error
When the HI32 is programmed to interface with a PCI bus and the HI function
is selected, this is the Host System Error signal.
Host Interrupt Request
When HI32 is programmed to interface with a universal, non-PCI bus and the
HI function is selected, this is the Host Interrupt Request signal.
Port B
When the HI32 is configured as GPIO through the DCTR, this signal is
internally disconnected.
This input is 5 V tolerant.
Host Stop
When the HI32 is programmed to interface with a PCI bus and the HI function
is selected, this is the Host Stop signal.
Host Write/Host Read-Write
When HI32 is programmed to interface with a universal, non-PCI bus and the
HI function is selected, this is the Host Write/Host Read-Write Schmitt-trigger
signal.
Port B
When the HI32 is configured as GPIO through the DCTR, this signal is
internally disconnected.
This input is 5 V tolerant.
Host Initialization Device Select
When the HI32 is programmed to interface with a PCI bus and the HI function
is selected, this is the Host Initialization Device Select signal.
Host Read/Host Data Strobe
When HI32 is programmed to interface with a universal, non-PCI bus and the
HI function is selected, this is the Host Data Read/Host Data Strobe Schmitt-
trigger signal.
Port B
When the HI32 is configured as GPIO through the DCTR, this signal is
internally disconnected.
This input is 5 V tolerant.
Host Frame
When the HI32 is programmed to interface with a PCI bus and the HI function
is selected, this is the Host cycle Frame signal.
Non-PCI bus
When HI32 is programmed to interface with a universal, non-PCI bus and the
HI function is selected, this signal must be connected to a pull-up resistor or
directly to V
Port B
When the HI32 is configured as GPIO through the DCTR, this signal is
internally disconnected.
This input is 5 V tolerant.
Host Interface (Continued)
CC
.
Signal Description
Freescale Semiconductor