82V2608BB IDT, Integrated Device Technology Inc, 82V2608BB Datasheet - Page 73

• Manufacturer Part Number: 82V2608BB
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of 82V2608BB

• Utopia Level: Level 2
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.97V
• Operating Supply Voltage (max): 3.63V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Package Type: BGA
• Pin Count: 208
• Mounting: Surface Mount
• Lead Free Status / Rohs Status: Not Compliant

8
about IMAOS08_Slave are provided in this chapter.
Group Auto Detect function and operates in Slave Mode.
8.1
group from one end while forcing the other end’s group to follow this
end’s group configuration and start-up procedure, that is, the other end’s
group can be brought into operational state automatically. The two ends
are called Master Side and Slave Side separately.
8.1.1
mode. Up to 4 groups can be started at the Master side.
Work Mode.
8.1.2
issuing the DeviceInitial, ConfigSlaveFrame, ConfigUtopiaIF and Grou-
pInitial commands. Only after the Slave Side has been initialized will the
Slave Side start to detect the far end’s start-up procedure.
operational state automatically without any need of local group configu-
ration and management.
IDT82V2608
IMAOS08_SLAVE
The previous chapters 4, 5, 6 and 7 are specific to IMAOS08. Details
When IMAOS08_Slave is downloaded, the device supports the
The group auto detect function can be used to configure and start a
The Master Side should download IMAOS08 and work in symmetry
The configuration of the Master Side is the same as that in normal
The Slave Side should download IMAOS08_Slave.
After power-on or reset, the Slave Side should be initialized by
After the far end has started up, the Slave Side will be brought into
IMAOS08_SLAVE
GROUP AUTO DETECT
MASTER SIDE
SLAVE SIDE
73
8.2
IMAOS08_SLAVE
8.2.1
8.2.2
8.2.3
Parameters and the Command Reply. In the Command Parameters
part, a figure is used to illustrate the byte sequence of the parameters.
All the parameters description are listed below the figure. In the
Command Reply part, a figure is used to illustrate the reply sequence in
the reply message. The reply description is listed below the figure. For
detailed information about the packet of command message and reply
message, refer to
Table-54 Command Encoding
Refer to
Each command description contains two parts: the Command
Command Encoding
PROGRAMMING INFORMATION FOR
COMMAND TYPES
COMMAND ENCODING
COMMAND DESCRIPTION
5.1 Command
01H
02H
03H
22H
23H
page
31.
Types.
Inverse Multiplexing for ATM
DeviceInitial
ConfigSlaveFrame
ConfigUtopiaIF
GetVersionInfo
GroupInitial
Command Name
December 4, 2006